User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Chapter 6: Configuration Using Web Manager
XPress DR+ User Guide 51
0x77FE Server Port
N/A
MTU Size
The Maximum Transmission Unit (MTU) is the largest physical
packet size a network can transmit for TCP and UDP. Enter
between 512 and 1400 bytes. The default setting is 1400
bytes.
3. When you are finished, click the OK button.
4. To save and reboot, on the main menu, click Apply Settings.
Host List Configuration
The XPress DR+ scrolls through the host list until it connects to a device listed in the host
list table. After a successful connection, the unit stops trying to connect to any others. If
this connection fails, the unit continues to scroll through the table until the next successful
connection.
The host list supports a minimum of 1 and a maximum of 12 entries. Each entry contains
an IP address and a port number.
Note: The host list is disabled for Manual and Modem Mode. The unit does not
accept a data connection from a remote device when the hostlist option is
enabled.
To configure the unit's host list:
1. On the main menu, click Hostlist.
Figure 6-4. Hostlist Settings
2. Enter or modify the following fields: