User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Chapter 1: Using This Guide
XPress DR+ User Guide 6
Remote Port_______________________________________________________ 79
DisConnMode _____________________________________________________ 79
Flush Mode (Buffer Flushing)__________________________________________ 80
Pack Control ______________________________________________________ 81
Packing Interval ________________________________________________________ 81
Trailing Characters______________________________________________________ 81
Send Characters _______________________________________________________ 82
DisConnTime (Inactivity Timeout) ______________________________________ 82
Send Characters ___________________________________________________ 82
Telnet Terminal Type ________________________________________________ 82
Channel (Port) Password_____________________________________________ 82
WLAN Settings (XPress DR+W Only) ___________________________________ 83
Topology______________________________________________________________ 83
Network Name (SSID) ___________________________________________________ 83
Adhoc Network Channel _________________________________________________ 84
WEP _________________________________________________________________ 85
WPA _________________________________________________________________ 86
WPA2/802.11i _________________________________________________________ 87
Fixed or Automatic Data Rate _____________________________________________ 87
Transmission Data Rate__________________________________________________ 87
Enable Power Management_______________________________________________ 87
Chapter 10: Setup Mode: Advanced Settings 88
Expert Settings (Option 5) ____________________________________________ 88
TCP Keepalive time in seconds ____________________________________________ 88
ARP Cache timeout in seconds ____________________________________________ 88
Disable Monitor Mode at bootup ___________________________________________ 88
HTTP Port Number______________________________________________________ 89
MTU Size _____________________________________________________________ 89
Enable alternate MAC ___________________________________________________ 89
Security Settings (Option 6) ___________________________________________ 89
Disable SNMP _________________________________________________________ 90
SNMP Community Name _________________________________________________ 90
Disable Telnet Setup ____________________________________________________ 90
Disable TFTP Firmware Upgrade __________________________________________ 90
Disable Port 77FE (Hex) _________________________________________________ 90
Disable Web Server _____________________________________________________ 91
Disable Web Setup______________________________________________________ 91
Disable ECHO Ports_____________________________________________________ 91