User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Chapter 6: Configuration Using Web Manager
XPress DR+ User Guide 61
Figure 6-9. WLAN Settings – Infrastructure Network Type
2. Enter or modify the following fields:
Wireless Network Configuration
Network Name (SSID)
Enter the name of the wireless network (SSID). The XPress
DR+W connects to this wireless network.
Network Type Select Infrastructure or Ad Hoc. The default setting is Ad
Hoc. Network type is also referred to as the network topology.
Channel Configurable only when Network Type is Ad Hoc. Select
from the pull-down menu the radio channel for the Ad Hoc
network. The default value is 11.