User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
XPress DR+ User Guide 64
Chapter 7: Configuration Using Telnet or Serial
Port (Setup Mode)
You must configure the unit so that it can communicate on a network with your serial
device. As an alternative to using a web browser, as described in the previous chapter,
you can use the following procedures remotely or locally:
Use a Telnet connection to configure the unit over the network.
Use a terminal or terminal emulation program to access the serial port locally.
The series of prompts at which you enter configuration settings is called Setup Mode.
Note: Detailed information about other setup methods is available from your
Lantronix Sales Associate.
The unit’s configuration is stored in nonvolatile memory and is retained without power.
You can change the configuration at any time. The unit performs a reset after the
configuration has been changed and stored.
This chapter tells you how to access Setup Mode and the general procedure for using it.
To complete the configuration, continue with Chapter 8: Setup Mode: Server
Configuration, Chapter 9: Setup Mode: Channel Configuration, and Chapter 10: Setup
Mode: Advanced Settings.
Notes:
The menus in the configuration chapters show a typical device. Your device may
have different configuration options.
For the latest firmware, release notes, and user documentation, go to the Lantronix
web site (www.lantronix.com).
To use Telnet for communication to an XPress DR+W over a wireless network, you
must first configure the network and WLAN settings using a serial connection. See
Chapter 4: XPress DR+W.
Accessing Setup Mode
Telnet Connection
To configure the unit over the network, establish a Telnet connection to port 9999.
Note: You can also use DeviceInstaller to access Telnet. Select the device from
the main window list, and click the Telnet Configuration tab. Skip steps 1 and 2
below.