User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Chapter 1: Using This Guide
XPress DR+ User Guide 7
Enable Enhanced Password ______________________________________________ 91
Default Settings (Option 7)____________________________________________ 91
Channel 1 and Channel 2 Configuration Settings ______________________________ 91
Expert Settings _________________________________________________________ 92
Security Settings _______________________________________________________ 92
WLAN Settings (XPress DR+W only)________________________________________ 92
Chapter 11: Firmware Upgrades 93
Obtaining Firmware _________________________________________________ 93
Reloading Firmware_________________________________________________ 93
Using TFTP: Graphical User Interface _______________________________________ 93
Using TFTP: Command Line Interface_______________________________________ 94
Recovering the Firmware Using the Serial Port and DeviceInstaller ________________ 94
Chapter 12: Monitor Mode 96
Entering Monitor Mode Using the Serial Port__________________________________ 96
Entering Monitor Mode Using the Network Port________________________________ 96
Monitor Mode Commands ________________________________________________ 96
Chapter 13: Troubleshooting and Technical Support 99
Problems and Error Messages ________________________________________ 99
Technical Support _________________________________________________ 102
Appendix A: Technical Specifications 103
Appendix B: Lantronix Cables and Adapters 105
Appendix C: Alternative Methods of Assigning an IP Address 106
DHCP _______________________________________________________________ 106
AutoIP_______________________________________________________________ 106
BOOTP______________________________________________________________ 107
ARP and Telnet _______________________________________________________ 107
Appendix D: Binary to Hexadecimal Conversions 108
Converting Binary to Hexadecimal_____________________________________ 108
Conversion Table ______________________________________________________ 108
Scientific Calculator ____________________________________________________ 108
Appendix E: Compliance Information 110
Declaration of Conformity ___________________________________________ 110
XPress DR+W Regulatory Information _________________________________ 112
USA Federal Communications Commission (FCC) Notice ______________________ 112
Canada – Industry Canada Notice _________________________________________ 112
Europe – R&TTE Directive 99/5/EC, Wireless Notice __________________________ 113