User's Manual
Table Of Contents
- Figures
- Tables
- Using This Guide
- Introduction
- Installation and Hardware
- XPress DR+W
- Using DeviceInstaller
- Configuration Using Web Manager
- Configuration Using Telnet or Serial Port (Setup Mode)
- Setup Mode: Server Configuration
- Setup Mode: Channel Configuration
- Channel 1 (Option 1) and Channel 2 (Option 2)
- Baudrate
- I/F (Interface) Mode
- Flow
- Port Number
- Connect Mode
- Send the Escape Sequence (+++) in Modem Mode
- Auto Increment Source Port
- Remote IP Address
- Remote Port
- DisConnMode
- Flush Mode (Buffer Flushing)
- Pack Control
- DisConnTime (Inactivity Timeout)
- Send Characters
- Telnet Terminal Type
- Channel (Port) Password
- WLAN Settings (XPress DR+W Only)
- Setup Mode: Advanced Settings
- Firmware Upgrades
- Monitor Mode
- Troubleshooting and Technical Support
- Technical Specifications
- Lantronix Cables and Adapters
- Alternative Methods of Assigning an IP Address
- Binary to Hexadecimal Conversions
- Compliance Information
- Warranty
Chapter 10: Setup Mode: Advanced Settings
XPress DR+ User Guide 92
Hostlist retry counter
3
Hostlist retry timeout
250 (msec)
Start character for serial channel 1
0x0D (CR)
All other parameters
0
Expert Settings
TCP Keepalive time in s
45
ARP Cache timeout in s
600
Disable Monitor Mode @ bootup
No
HTTP Port Number
(1-65535)
80
MTU Size (512 – 1400)
0 (resulting in an operational value of 1400)
Enable alternate MAC
No ( for OEM use only)
Ethernet Connection Type
0 (auto-negotiate)
Security Settings
Disable SNMP
No
SNMP community name
public
Disable Telnet setup
No
Disable TFTP Firmware Update
No
Disable Port 77FEh
No
Disable Web Server
No
Disable Web Setup
No
Disable ECHO ports
Yes
Enable Enhanced password
No
WLAN Settings (XPress DR+W only)
Topology
1 (AdHoc)
Network Name
LTRX_IBSS
Channel
11
Security suite
0 (none)
TX Data Rate
0 (fixed)
TX Data Rate
11 Mbps
Enable Power Management
N (No)