OWNER’S MANUAL VBD2600MP RX V O LU MO SEL DE ME AS/PS PAU 1 INT 2 RPT 3 4 RDM 5 6 FULL LOGIC MOTORIZED SLIDE DOWN & FULL DETACHABLE PANEL CAR CD / MP3 /WMA PLAYER / RECEIVER
BUTTONS LOCATION SUBWOOFER BUTTON DISPLAY BUTTON 14 7 6 3 PANEL RELEASE MENU MUTE BUTTON BUTTON BUTTON 15 5 PRESET PANEL EQUALIZER IXBASS OPEN BUTTON BUTTON BUTTON RX V O LU MO SEL DE ME AS/PS SELECT BUTTON LO/DX BUTTON 9 17 PAU 1 INT 2 RPT 3 4 RDM 5 6 PRESET STATIONS BUTTONS MODE SCAN BUTTON BUTTON 12 2 11 MP3 / WMA ENTER BUTTON 18 REMOTE CONTROL RECEIVER RX V O LU MO SEL DE ME AS/PS VOLUME UP/DOWN BUTTON 4 PAU 1 AUTOMATICALLY STORE / PRESET SCAN (AS/PS) BUT
HANDLING COMPACT DISCS MOISTURE CONDENSATION On a rainy day or in a very damp area, moisture may condense on the lenses inside the unit. Should this occur, the unit will not operate properly. In such a case, remove the disc and wait for about an hour until the moisture has evaporated. NOTES ON CDs NOTES ON DISCS 1. A dirty or defective disc may cause sound dropouts while playing. To enjoy optimum sound, handle the disc as follows. Handle the disc by its edge.
1. INSTALLATION Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and system work properly. Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions. Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
Removing the unit a a. Frame b. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When re-attaching the frame, point the side with a groove down wards and attach it.) c. Insert the levers supplied with the unit into the grooves at both sides of the unit as shown in figure until they click. Pulling the levers makes it possible to remove the unit from the dashboard. b c Trim Plate Installation: Push the trim plate against the chassis until it is fitted.
2. DETACHABLE CONTROL PANEL (D.C.P.) Removing The Detachable Control Panel (D.C.P.). 1. Turn the power off 2. Press the D.C.P. release button 3. Remove the D.C.P. PANEL RELEASE BUTTON Attaching the DCP 2 A B 1. Attach the panel at the right side first, with point B on the main unit touching point A on the D.C.P. (As shown on the diagram). 2. Then press the left side of D.C.P. onto the main unit until a “click” sound is heard. CAUTION DO NOT insert the D.C.P from the left side. Doing so may damage it.
3. WIRING DIAGRAM (20 PIN HARNESS PLUG) YELLOW FUSE ANTENNA EXTENDER CABLE ANTENNA JACK 20-PIN AUDIO/POWER HARNESS BLUE SUB WOOFER RCA-TO-RCA CABLES (NOT SUPPLIED) WHITE SUB-WOOFER R-CH GREY REAR LINE OUT WHITE BLACK FRONT LINE OUT WHITE AUX IN RCA-TO-RCA CABLES (not supplied) L-CH L-CH RED WHITE (See Figure 1) R-CH RED L-CH AMP R-CH RED BLUE Power Antenna Connect to power antenna or amplifier, If not used,Tape bare end of wire.
4.PANEL OPEN/CLOSE OPERATION (MOTORIZED SLIDE DOWN VERSION) This unit is equipped with the most advanced full logic motorized slide down system. You can enjoy this advance technology with just a single press of the “OPEN” button Please read carefully the following operation instruction before operating the unit. OPEN / CLOSE THE PANEL: Press the Open button to slide down (open) a closed panel or to slide up (close) an opened panel.
5. BASIC OPERATIONS 14) PANEL RELEASE BUTTON ( ) Press this button to remove the control panel. 1) POWER ON/OFF BUTTON ( ) Press POWER button or any other button on the front of the radio (except Open/Eject)to turn the unit on. Press POWER button again to turn the unit off. 2) MODE BUTTON (MODE) Press MODE button to select a different mode of operation as indicated on the display panel. Available modes include Tuner, CD, MP3,WMA and Aux in .
Balance Press the sel button five times, then use the volume up/ down button to adjust the balance between the right and left speakers from R12 (full right) to L12 (full left). “C00” Represents a center balance level between the right and left speakers. Fader Press the sel button six times, then use the volume up/ down button to adjust the fader between the front and rear speakers from R12 (full rear) to F12 (full front). "C00” Represents a center fader level between the front and rear speakers.
7) MENU FUNCTION LIST (MENU) Press DISPLAY/MENU to access the menu. "Menu" will appear in the display momentarily. Navigate the menu by pressing DISPLAY/MENU momentarily to move forward to the next option. The menu can also be navigated by using the Tuning Up or Tuning Down Button to move to the next or previous option. Once the desired option appears in the display, adjust that option by using the volume control up or down within 5 seconds. The following options are adjusted through this menu feature.
Illumination Color (COLOR) This option allows selection between two colors for the backlight illumination of the unit. "COLOR 1" is the default color and will illuminate the unit with blue backlight. Use volume up/down button to select "COLOR 2”,, which will illuminate the unit with red backlight.
GREETING NOTE There are three different greeting note displayed on LCD base on different condition. 1.When the unit is powered on, one of three greeting will display based on the time of day: Good Morning, Good Afternoon or Good Evening. 2. When the unit is powered off but the ignition remains on, the LCD will scroll through the following messages if the selectable clock display feature is activated: “Enjoy Driving! Have a Safe Trip!” 3.
6. TUNER OPERATION 8) BAND BUTTON (BAND/SERACH) Press BAND to change between FM bands and AM(MW) bands. Each band stores up to 6 preset stations. 10) TUNING UP/DOWN BUTTON ( ) Manual Tuning Press the Up Tuning or Down Tuning button for more than 3 seconds to move the radio frequency number up or down one step. Auto Seek Tuning Press the Up Tuning or Down Tuning button for less than 3 seconds to move to next station automatically.
7. CD PLAYER OPERATION INSERT AND EJECT CD Insert a CD label-side up with the unit turned on, and the disc will begin to play. Press the Eject button to stop CD play and eject the CD. The unit does not have to be turned on to eject the CD. PAUSE BUTTON (PAU) Press the pause button to suspend disc play. Press the pause button again to resume disc Play.
8. MP3/WMA OPERATION MP3 and WMA (Windows Media Audio) music files are digital audio files that are compressed to allow more files on a single CD. This unit can play MP3/WMA directly from files contained on a CD-R/RW using the buttons on the receiver (or optional remote).Depending on the media type and recording method, some CD-R/RW's may be incompatible with this unit.
Writing Files into a Medium When a medium containing MP3/WMA data is loaded, the unit checks all data. If the medium contains many folders or non-MP3/WMA files, MP3/WMA play will be delayed, it may take time for the unit to move to the next file, and searches may not be performed smoothly. Loading such a medium may produce loud noise and cause damage to the speakers. Do not attempt to play a medium containing a non-MP3/WMA file with the MP3/WMA extension or a medium containing non MP3/WMA files.
FILE/FOLDER PLAY There are three different play methods as following: File/Folder Intro play: Press M2 button more than 3 seconds during playing MP3/WMA disc for “intro play” all files of the current folder. Intro play should restart from the first song of the current folder, after all files in the current files have been intro-played. To disable current folder “intro play”, long press M2 button more than 3 seconds Press M2 button less than 3 seconds is “intro play” all files on the disc.
9.MP3/WMA FILE OR FOLDER SEARCHING The unit allows end user have three different method for the file / folder searching. 1)Direct file number searching. “014 MP3 file” Press MP3 search button (Band button) once LCD will display “number search”, Press “Audio Select” key or press volume down/up button to enter the “Number search”. Press volume down up button until “014” Long Press MP3 enter button (Audio Select button) to confirm & play file “014” 2) Folder /files Navigate searching.
ID3 INFORMATION DISPLAY If any MP3/WMA file recording with ID3 Tag information. The ID3 information such like Album title, Track title, Artist Title will be displayed and automatic scrolling through the LCD while the file is playing. User also allows pressing the AS/PS button repeatedly to view the ID3 tag information manually.
10.REMOTE CONTROL 1 3 8 2 4 7 14 11 6 1 2 3 4 5 6 9 12 5 13 10 OPERATIONS: Key Radio Mode CD Player Mode MP3/WMA Mode 1. Power ( ) Power On/Off Power On/Off Power On/Off 2. Select(SEL)/Enter Select Vol, Bas, Tre, Fad, Bal Sub-woofer Select Vol, Bas, Tre, Fad, Bal Sub-woofer Select Vol, Bas, Tre, Fad, Bal, MP3enter Sub-woofer 3. Volume Up/Down Adjust Vol,Bas, Tre,Fad,Bal Sub-woofer Adjust Vol,Bas, Tre,Fad,Bal Sub-woofer Adjust Vol,Bas, Tre,Fad,Bal Sub-woofer 4.
11.SPECIFICATIONS CD PLAYER System Usable disc Sampling frequency No of quantization bits Frequency Number of channels S/N Ratio Compact disc audio system Compact disc 44.1KHz 1bit 5-20,000Hz 2 stereo 70dB RADIO SECTION FM Frequency Range Intermediate Frequency Usable Sensitivity Stereo Separation S/N Ratio 87.5-107.9 MHz 10.
12.TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom No power Disc cannot be loaded or ejected Cause Solution The car ignition is not on. If the power supply is properly connected to the car accessory terminal, switch the ignition key to “ACC” The fuse is blown. Replace the fuse. Presence of CD disc inside the player.
