4-Band Parametric Equalizer with Wireless BT Audio Connectivity
TABLE OF CONTENTS 1. FEATURES 3 2. PRECAUTIONS 4 Installation 4 3. CONTROLS 5 4. OPERATIONS 6 Setting system volume 6 Adjusting the controls 6 Setting the low-pass frequency 6 Connecting an MP3 player or video unit 7 Care and maintenance 7 5. INSTALLATION AND WIRING 8 What's in the Box 8 Before starting 8 Tools and additional components 9 Mounting Diagram 9 Wiring diagram 6.
FEATURES LANZAR HTGEPBT9H is a 4-band stereo equalizer/ crossover specifically created for the mobile environment.
PRECAUTIONS • Do not operate this product in ways other than those described in this manual. • Do not disassemble or modify this unit. • Do not pour liquid or poke foreign objects into the unit. Water and humidity may damage internal circuitry. • If the unit becomes wet, turn off all power and ask your authorized LANZAR dealer to clean or service the unit. Failure to observe these precautions may damage your ear, the monitor, or the video source, and may void the warranty.
CONTROLS www.Lanzar.
OPERATIONS Setting system volume 1. Turn the master volume and subwoofer level controls to their minimum settings. 2. Turn the source unit on and increase the volume until you hear distortion. 3. Reduce the volume to just below the distortion point (approximately 80% of full volume). This is the maximum usable musical signal for the source unit. Turning the volume beyond this point increases noise and distortion without increasing the musical signal.
Connecting an MP3 player or video unit 1. Plug the MP3 player or video unit into the auxiliary RCA input on the back of the HTGEPBT9H unit. 2. Make sure the auxiliary button on the front of the unit is out, ready to receive input from the main RCA input (not the auxiliary RCA input). 3. Turn the HTGEPBT9H master volume to a normal listening level. 4. Press the play button on the auxiliary source. 5. Push in the AUX button to change to the auxiliary source. 6.
INSTALL ATION AND WIRING Read these instructions and the following precautions carefully. What's in the Box: • 4-Band Parametric Equalizer Before Starting Mounting Precautions The HTGEPBT9H can be mounted next to the source unit or under the dash using the mounting brackets. The front panel controls should be easily accessible from the driver's seat. In addition: • This unit requires additional mobile audio components for proper operation.
Tools and additional components You will need: • A Philips-head screwdriver when mounting the unit in the vehicle. • A small flat-head screwdriver to adjust the AUX gain controls if you connect an MP3 player or video source. • High-quality RCA input and output cables. Extra cable can cause signal loss and act as an antenna for noise. Use only high-quality RCA cables that are no longer than necessary to make a direct connection with the source unit and amplifiers. Mounting Diagram www.Lanzar.
Wiring Diagram WARNING: Please pay attention that the power connection of 12 Volts + is connected to a accessory switch controlled power lead. It should only receive current when the acc. key is turned on. If you connect this wire directly to the battery the amp will be powered on and drawing power even when your car is turned off. This will cause a battery drain and failure to start your car. 10 www.Lanzar.
Wiring Diagram www.Lanzar.
Troubleshooting The unit does not work: No lights The power wires may not be connected. Check the power and ground wiring, then retest. Sound is Distorted • The source unit volume may be set too high. Reduce the source unit volume. • Equalizer gain controls are set too high. Turn the equalizer controls to the center position and listen for distortion again. If the problem still occurs, see your authorized LANZAR dealer. • Speakers may be damaged. Consult your authorized LANZAR dealer.
Specifications Features: • Half Din Size • Pre-amp Line Aux Inputs Via RCA Jacks • Input Gain Adjustments • Voltage LED indicator • Wireless BT Audio Connectivity • 3.
Questions? Issues? We are here to help! Phone: (1) 718-535-1800 Email: support@lanzar.