OWNER’S MANUAL VBD 300 PLL SYNTHESIZER STEREO RADIO WITH COMPACT DISC PLAYER DIGITAL
INSTALLATION Notes: • Choose the mounting location where the unit will not interfere with the normal driving function of the driver. • Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit and the system work properly. • Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause malfunctions.
1. Dashboard 1 2. Nut (5mm) 6 3. Spring washer 7 4 2 4. Screw (5 x 25mm) 5 5. Screw 3 6. Strap Be sure to use the strap to secure the back of the unit in place. The strap can be bent by hand to the desired angle. (Fig. 2) 7. Plain washer Removing the unit 1. Frame 1 2. Insert fingers into the groove in the front of frame and pull out to remove the frame. (When reattaching the frame, point the side with a groove downwards and attach it.) 2 3 3.
HOW TO REMOVE AND INSTALL THE FRONT PANEL (OPTIONAL) 1. Press the release button and pull-off the front panel. Keep front panel into the case. 2. To install the front panel, insert the panel into the housing and make sure the panel is properly installed, otherwise, abnormalities occurs on the display or some keys will not function properly.
WIRING CONNECTION FOR 4 X 25W OR 4 X 40W SYSTEM CD CHANGER CONNECTOR SOCKET (FOR CD CHANGER VERSION ONLY) MAIN UNIT CD INPUT CABLE ANTENNA CONNECTOR (BLACK) (FOR CD INPUT VERSION ONLY) SUBWOOFER CABLE IGNITION SWITCH (B+) RED MEMORY BACK-UP YELLOW (GREEN) (FOR SUBWOOFER VERSION ONLY) GROUND (B–) BLACK (BROWN) CHOKE BOX Rch RED FRONT RCA CABLE Lch WHITE (GREY) BLUE POWER ANTENNA Rch RED REAR RCA CABLE Lch WHITE (FOR RCA LINE OUT VERSION ONLY) FRONT Lch SPEAKER + – REAR Lch SPEAKER
LOCATION AND FUNCTION OF CONTROLS 24 14 8 11 9 15 26 10 17 2 19 13 18 16 20 6 21 4 22 25 12 3 7 1 5 23 27 (1) ON/OFF Press POWER button (1) to turn on. Press it again to turn it off. If the power is off, press BND button (11) or MOD button (12) also can turn on the unit. (2) DISC PLAY Gently insert a compact disc with the label side facing up into the disc slot (2). The disc is then automatically loaded into the unit and starts playing with the first track of the disc.
(4) MONO/STEREO (FOR MON VERSION ONLY) Press MON button (4) to select monaural or stereo (Mono reception for radio stations). You can sometimes improve reception of distant stations by selecting mono operation. (4) SUB-WOOFER (FOR SUB.W. VERSION ONLY) Press X-BAS button (4) to toggle sub-woofer output, when sub-woofer on, display will show “ SW”. (5) LOUDNESS Press LOU button (5) to increase bass output and display will show “LOUD”.
(13) LIQUID CRYSTAL DISPLAY The LCD (13) can show the current state of the unit. (14 & 15) SELECT STATIONS Press and release a TUNE/SEEK/TRACK button /– (14) or +/ (15) immediately to move radio frequency number up or down on step. Press and hold a TUNE/SEEK/TRACK button /– (14) or +/ (15) for several seconds to seek the next clear station. (14 & 15) SKIP TRACKS Press a TUNE/SEEK/TRACK button /– (14) or +/ (15) to move to the previous track or the following track. Track number shows on the display.
(23) AUTOMATICALLY STORING & PROGRAM SCANNING Automatically Storing Press and hold AMS button (23) for several seconds to toggle automatically storing function. It starts searching next frequency in local mode and stores the clear station into the preset memory. If 6 ch. is not fully memorised, it would start the second searching in distance mode. At the end of automatically storing operation, mode is changed to Preset Scan. Preset Scanning Press AMS button (23) shortly to toggle preset scanning function.
Remote Control Handset 3 9 8 1 2 4 5 Control & Function Keys 6 7 10 13 14 12 11 15 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. 15.
SPECIFICATION GENERAL Power Supply Requirements Chassis Dimensions Tone Controls - Bass (at 100 Hz) - Treble (at 10 KHz) Maximum Output Power - Version v - Version z - Version y : DC 12 Volts, Negative Ground : 178 (W) x 155 (D) x 50 (H) : +10 dB / –10 dB : +10 dB / –10 dB : 7W x 4 (ch) or 25W x 2 (ch) : 25W x 4 (ch) : 40W x 4 (ch) CD PLAYER Signal to Noise Ratio Channel Separation Frequency Response : More than 60 dB : More than 60 dB : 20 Hz - 20 KHz RADIO For 3 Bands (Europe) FM 87.5 to 108 MHz 10.
TROUBLE SHOOTING Before going through the check list, check wiring connection. If any of the problems persist after check list has been made, consult your nearest service dealer. Symptom No power. Disc cannot be loaded or ejected. No sound. Cause Solution The car ignition is not on. If the power supply is properly connected to the car accessory terminal, switch the ignition key to “ACC”. The fuse is blown. Replace the fuse. Presence of CD disc inside the player.