Data Sheet

U.I. Lapp
GmbH
DATA SHEET
ÖLFLEX
®
EB CY
DB 0012640
valid from: 18.10.2010
Originator: R. Krämer / PDC
approved: H. Schillinger / PDC
Document: DB0012640EN Page 1 of 1
All deviations from this specification are subject to explicit consent of U.I. Lapp GmbH. All rights reserved acc. to DIN 34.
PD 0019/2.1_11.09EN
Application
ÖLFLEX
®
EB CY are PVC control cables with blue outer sheath for occasional flexible use and fixed installation in intrinsi-
cally safe circuits. They are among others designed for use in dry, damp and wet rooms. Outdoor use is not allowed. At room
temperature they are widely resistant to certain oils and resistant to acids. Continuous operation movement, compulsory
guidance respectively usage on cable drums or pulleys or under a tensile strain of more than 15 N / mm² conductor cross
section are not allowed.
Application range: In explosive atmosphere with hazard area type “ i “ – intrinsically safety; the cables meet the require-
ments of VDE 0165-1 (DIN EN 60079-14). The screen is a protection against electrical interference.
Design
Design based on HD 21.13 S1 resp. VDE 0281-13
Conductor fine wire strands of bare copper acc. to IEC 60228 resp. VDE 0295, Class 5
Core insulation LAPP special PVC compound P8/1, better than the PVC compound TI2
acc. to HD 21.1 S4 resp. VDE 0281-1
Core identification acc. to VDE 0293-1, without GN/YE ground conductor
black cores with white numbers
acc. to DIN EN 50334 resp. VDE 0293 part 334
Wrapping plastic foil
Screen braid of tinned copper, coverage = 85% (nominal value)
Outer sheath PVC compound TM2 acc. to HD 21.1 S4 resp. VDE 0281-1
Colour: Blue, similar RAL 5015
Electrical properties
Nominal voltage < 50 V AC
< 75 V DC
Test voltage C/C: 3000 V AC
C/S: 2000 V AC
Mechanical and thermal properties
Min. bending radius occasional flexing: 20 x cable diameter
fixed installation: 6 x cable diameter
Temperature range occasional flexing: -5 °C up to +70 °C max. conductor temp.
fixed installation: -40 °C up to +80 °C max. conductor temp.
Flammability flame retardant in acc. to IEC 60332-1-2 resp. VDE 0482-332-1-2
Tests acc. to IEC 60811 resp. VDE 0473 part 811 and VDE 0472
Because this product is designed for intended use in the voltage range of < 50 V AC resp. < 75 V DC, it is not subject to the
Low Voltage Directive 2006/95/EC. Thus a CE marking is not applicable.