Data Sheet

Product Information
Page 2 of 2
EPIC® Data CAN-Bus Connectors 90° Valid: 07.02.2012
• Adjustable termination resistor is integrated
• The integrated, connectable terminal resistors enable the CAN-Bus to be terminated or connected through
• When used as a through connector, the switch must be in the "OFF" position. If used as a terminating connector,
the switch must be in the "ON" position.
• No loose parts
Technical Data
Dimensions
65 mm x 48 mm x 16 mm (LxWxH)
Terminating resistor
120 ohms integrated, and connectable with slide
switch
Connection type
Screwing
Weight
Approx. 40 g
Cable outlet
90°
Interfaces
CAN bus station: SUB-D socket, 9-pinCAN bus cable: 6
terminal blocks for wires up to 1.0 mm²
Sub-D pin assignment: CAN Low = Pin 2 CAN High = Pin
7 CAN Gnd = Pin 3 GND = Pin 6 CAN V+ = Pin 9
Protection rating
IP20
Transmission rate
max. 1 MBit/s
Degree of soiling
2
Permissble ambient conditions
Operating temperature: 0°C to +60°C Transport and
storage temperature: -25°C to +75°C Relative humidity:
max. 75 % at +25°C
Article List
Part
number
Article
designation
Cable
outlet
PG
Pieces
/ PU
EPIC® data CAN bus connectors
21700537 ED-CAN-90 90° no 1
21700536 ED-CAN-90-PG 90° yes 1
Footnote:
Unless specified otherwise, the shown product values are nominal values. Detailed values (e.g. tolerances) are available
upon request.
Photographs are not to scale and do not represent detailed images of the respective products.
For detailed technical information please refer to www.lappautomation.com