Datasheet

ManualsBrandsLAPPKABEL ManualsIndustrial Data CablesControl wiring ÖLFLEX® CLASSIC 110 ORANGE 3 G 1 mm² Orange 100 m

U.I. Lapp

GmbH

DATA SHEET

ÖLFLEX

CLASSIC 110 ORANGE

DB 0019700

valid from: 15.11.2012

Originator: KASC / PDC

Approved: HAPF / PDC

Dokument: DB0019700EN Page 1 of 1

PD 0019/2.2_11.10EN

Application

ÖLFLEX

CLASSIC 110 ORANGE cables are PVC-insulated power and control cables for flexible use and fixed installation for

normal mechanical stresses. They are among others designed for use in dry, damp and wet rooms. Outdoor use: They may

only be installed with UV protection and considering the temperature range. At room temperature they are widely resistant

to acids, alkali-resistant and resistant to certain oils. They are suitable for free non-continuously recurring movement without

tensile load or compulsory guidance.

Application range:

Interlocking control circuits acc. to DIN EN 60204-1 VDE 0113-1, electrical lighting and socket circuits for maintenance or

repair purposes.

This cable is suitable for torsion application in wind turbines (WTG). The torsional load is limited to applications, as they

typically occur in the loop of a wind turbine.

Design

Design based on HD 21.13 S1 resp. VDE 0281-13

Conductor fine wire strands of bare copper, acc. to IEC 60228 resp. VDE 0295, Class 5

Core insulation LAPP special PVC compound P8/1, better than the PVC compound TI2

acc. to VDE 0281-1

Core identification acc. to VDE 0293-1, with or without GN/YE ground conductor

orange cores with black numbers acc. to DIN EN 50334 resp. VDE 0293-334

Outer sheath PVC compound TM2 acc. to VDE 0281-1 with increased requirements

acc. to LAPP specification

colour: Orange, similar RAL 2003

Electrical properties

Nominal voltage 300 / 500 V

Test voltage 4000 V AC

Mechanical and thermal properties

Min. bending radius occasional flexing: 15 x cable diameter

Fixed installation: 4 x cable diameter

Temperature range fixed installation: -40 °C to +80 °C max. conductor temp.

occasional flexing: -5 °C to +70 °C max. conductor temp.

Torsion movement in WTG TW-0 (5000 cycles at ≥ +5°C)

TW-1 (2000 cycles at ≥ -20°C)

± 150 °/m at 1 revolution per minute

Flammability flame retardant in acc. with IEC 60332-1-2 resp. VDE 0482-332-1-2

Tests acc. to IEC 60811 resp. VDE 0473 and VDE 0472

EC Directives These cables are conform to the EC-Directives 2006/95 EC (Low Voltage Directive) and

ECD 2002/95/EC (RoHS, Restriction of the use of certain hazardous substances).