Datasheet

DATA SHEET
0034190
UNITRONIC® JE-Y(ST)Y…BD
valid from:
05.08.2009
Erstellt: TE-K, Petra Samek Dokument: DB0034190EN03 Seite 1/1
Alle Abweichungen von diesen Angaben bedürfen der Zustimmung der U.I.LAPP GmbH. Wir behalten uns alle Rechte gemäß DIN 34 vor.
Nr.: 0018/0408
APPLICATION
UNITRONIC® JE-Y(ST)Y…BD is a connecting cable for industrial electronics. It can be used in measurement and
control engineering and also as pulse and data transmission cable.
With the blue outer sheath the cable is designed for the installation of intrinsically safe circuits in hazardous
(explosive) areas.
The cable meets the requirements of VDE 0165 part 1 where a special marking for cables of hazard type “i”
(intrinsically safe) is specified.
The cable is manufactured according to DIN VDE 0815. The requests for make-up and electrical quality of this
norm are fulfilled.
The cable is suited for limited flexing use and fixed installation in dry and wet rooms on and under plaster.
DESIGN
Design: nach DIN VDE 0815, table 4, Bauart JE-Y(ST)Y...BD
TECHNICAL DATA
Electrical properties nach DIN VDE 0815, Tabelle 10, Bauart JE-Y(ST)Y…BD
Operating peak voltage (not for power use) 225 V
Test voltage C/C 500 V
Test voltage C/C 2000 V
Loop resistance 73,2 Ohm/km
Specific insulation resistance > 100 MOhm x km
Mutual capacitance 100 nF/km
Coupling 200 pF/100m
Inductance 0,65 mH/km
Minimum bending radius fixed installation 6 x cable diameter
Temperature range fixed installation -30 C to +70 C
Flammability flame retardant acc. to IEC 60332-1-2
Tests at the cable acc. to DIN VDE 0815, Tabelle 21