Datasheet

ManualsBrandsLAPPKABEL ManualsIndustrial Data CablesServo lead ÖLFLEX® SERVO 720 CY 6 x 0.14 mm² + 2 x 0.5 mm² Grey 50 m

U.I. Lapp

GmbH

DAT

A SHEET

ÖLFLEX

SERVO 720 CY

DB 0036170

valid from: 2013-02-01

Originator: KASC / PDC

approved: HAPF / PDC

Document: DB0036170EN Page 1 of 2

PD 0019/2.2_11.10EN

Application

ÖLFLEX



SERVO 720 CY cables are screened sensor leads for servo motors. They are among others designed for use in dry,

humid and wet conditions. Outdoor use: They may only be installed with UV protection and considering the temperature

range. At room temperature they are widely resistant to acids, caustic solutions and certain oils. Continuous operational

movements, restricted guidance, usage of these cables in moving cable carriers, respectively on motor drum guidance or

under a strain of more than 15 N/mm² is not allowed. The screen (0 036 170 with drain wire) is a protection against electri-

cal interference.

Application range:

analogue and incremental encoders in servo drives, as well as for measurement, control and electrical application

Design

Design based on

DIN EN 50525-1 resp. VDE 0285-525-1 and DIN VDE 0812 +A1

Conductor fine wire strands of bare copper acc. to IEC 60228 resp. VDE 0295, Class 5

Core insulation PVC compound TI2 acc. to EN 50363-3 resp. VDE 0207-363-3

Core identification coloured, see p. 2

Screening braid of tinned copper wires, coverage = 85 % (nominal value)

Outer sheath PVC compound TM2 acc. to EN 50363-4-1 resp. VDE 0207-363-4-1

colour: silver grey, similar RAL 7001

Electrical properties

Nominal voltage 48 V AC

(not for power current application)

Peak working voltage 350 V U

Test voltage C/C: 2000 V AC

C/S: 1000 V AC

Mechanical and thermal properties

Min. bending radius occasional flexing: 20 x cable diameter

fixed installation: 6 x cable diameter

Temperature range occasional flexing: -5 °C up to +70 °C max. conductor temp.

fixed installation: -40 °C up to +80 °C max. conductor temp.

Flammability flame retardant in acc. with IEC 60332-1-2 resp. VDE 0482-332-1-2

Tests acc. to IEC 60811 resp. VDE 0473 part 811 and VDE 0472

EC –Directives These cables are conform to the EC-Directives 2011/65/EU (RoHS, Restriction of the

use of certain hazardous substances). As this product is designed for appropriate use in

a voltage range of < 50 V AC resp. < 75 V DC, it is not subject to the Low Voltage Di-

rective 2006/95/EC. Thus the CE marking is not applicable.