Datasheet

ManualsBrandsLAPPKABEL ManualsIndustrial Data CablesDrag chain cable ÖLFLEX® CHAIN 808 CP 3 G 0.5 mm² Grey 100 m

U.I. Lapp

GmbH

DATA SHEET

ÖLFLEX

CHAIN 808 CP

DB 1027751

valid from: 2014-02-21

Originator: KASC / PDC

approved: HAPF / PDC

Document: DB00127751EN

Page 1 of 1

PD 0019/2.2_11.10EN

Application

ÖLFLEX



CHAIN 808 CP cables are high-flexible oil-resistant power and control cables with an outer sheath of Polyurethane

for flexible use and fixed installation under light or medium mechanical load conditions. They are among others designed for

use in dry, damp or wet rooms. Considering the indicated temperature range an outdoor use is possible. ÖLFLEX



CHAIN

808 CP cables are increased oil resistant and at room temperature widely resistant to acids and caustic solutions. The outer

sheath is resistant to high mechanical load, particularly to abrasion and scouring, cut resistant, microbe-proof and hydrolysis

resistant. They are especially suitable for basic requirements (Basic Line) in power chains and in permanently moved ma-

chine parts. Usage of these cables in moving cable carriers or on motor drum guidance or under a tensile strain of more

than 15 N/mm

conductor cross-section is not allowed. The screen is a protection against electrical interference.

Application range:

Power chains or moving machine parts, especially in wet areas of machine tools and transfer lines, measuring, control

and regulation circuits.

Design

Design based on

DIN EN 50525-2-21 resp. VDE 0285-525-2-21 and

DIN EN 50525.2.51 resp. VDE 0285-525-2-51

Conductor fine wire strands of bare copper acc. to IEC 60228 resp. VDE 0295, Class 5

Core insulation LAPP special PVC compound P8/1, better than the PVC compound TI2

acc. to DIN EN 50363-3 resp. VDE 0207-363-3

Core identification acc. to VDE 0293-1, with or without GN/YE protective conductor

black cores with white numbers

acc. to DIN EN 50334 resp. VDE 0293-334

Taping non-woven wrapping

Screen braid of tinned copper wires, coverage = 85% (nominal value)

Outer sheath Polyurethane compound TMPU acc. to EN 50363-10-2 resp. VDE 0207-363-10-2

Colour: grey, similar RAL 7001

Electrical properties

Nominal voltage U

/U: 300/500 V

Test voltage Core/Core: 4000 V AC

Core/Screen: 2000 V AC

Mechanical and thermal properties

Min. bending radius flexing up to 3m travel distance (horizontal, self supporting): 10 x cable diameter

flexing up to 10m travel distance (horizontal, sliding): 12 x cable diameter

fixed installation: 4 x cable diameter

Number of bending/unbending

cycles 2 mio. cycles

Travel distance 10 m

Temperature range flexing: -5 °C up to +70 °C max. conductor temp.

fixed installation: -40 °C up to +80 °C max. conductor temp.

Oil resistance acc. to EN 50363-10-2 resp. VDE 0207-363-10-2

Tests acc. to IEC 60811 resp. VDE 0473 part 811, EN 50395, EN 50396

EC Directives This cable is conform to the EC-Directives 2006/95/EC (Low Voltage Directive)

and 2002/95/EC (RoHS, Restriction of the use of certain hazardous substances).