User's Manual
Table Of Contents
- 1 MXi201V AMPLIFIER–INTRODUCTION
- 2 SAFETY NOTICES
- 2.1 Beryllium Oxide Warning
- 2.2 Other Toxic Materials
- 2.3 Dangerous Voltages
- 3 LARCAN PARTS, ASSEMBLIES, ASSEMBLY DRAWINGS AND SCHEMATIC NUMBERS
- 1 MXi CONTROLLER
- 2 AMPLIFIER INSTALLATION AND STARTUP
- 3 TEST AND TROUBLESHOOTING
- 4 MAINTENANCE
- 5 SERVICE
- 6 TEST EQUIPMENT SETUP
- 7 SPECIFICATIONS
- 1 MXi DUAL PALLET VHF AMPLIFIER
- 1 FUNCTIONAL DESCRIPTION:
- 2 RF PREAMPLIFIER
- 3 POWER AMPLIFIER:
- 4 TWO-WAY SPLITTER/COMBINER
- 5 ADJUSTMENT OF BIAS VOLTAGE TO ESTABLISH PROPER QUIESCENT FET BIAS CURRENT:
- 6 LOW POWER SWEEP AMPLIFIERS
- 1 MXi POWER SUPPLY LAR1000-50-P5337
- 2 POWER SUPPLY DATA SHEET REPRINT
MXiV DUAL PALLET OPERATIONS AND MAINTENANCE
1 MXi CONTROLLER
The MXi control board (Assembly 31C1897) is a single-circuit assembly that provides all of the control functions
required for the MXi series of transmitters on a single circuit board. This board can be configured for a number of
different transmitter types, power levels, transmission standards and options.
Figure 2 MXi Controller
The MXi control board provides local front panel interface via ON/OFF and RESET buttons as well as a graphical
user interface through a front panel LCD assembly with touchpad for user commands. The board implements
controls/status/telemetry for remote control through a rear panel connector that will interface to a typical remote
control systems (such as Moseley or Gentner). An RS232 serial port is also provided to allow the operator to
access the MXi through an external computer (with the appropriate software). The MXi control board has RF
detectors for forward and reflected power and all the circuitry to support AGC/VSWR/Cutback functions. Circuitry
to control and monitor the +50V power supply is also included on this board.
Figure 3 MXi Front Panel
The user interface to the amplifier is accomplished with the front panel LCD that incorporates a touchpad as an
integral part of the unit. The LCD has the capability of displaying a variety of screens, which are selected by the
user via the touchpad.
Figure 4 shows the LCD main menu, which shows the present status of the amplifier along
with the selections of submenus.
Figure 4 Main Menu Screen
TSM21Q-365 Rev 0 July 17, 2009 MXiV Dual Pallet Operations and Maintenance 12