Assembling & Installation Instructions

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed.
However, the installation instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1)
1. Shut off the power at the circuit breaker box. Remove old fixture and
all hardware from Junction Box.
2. Carefully unpack your new fixture and lay out all the parts on a clear
area. Be care not to lose any small parts necessary for installation.
3. While holding the lamp body(C) towards the ceiling, attach the single
bar to the Junction Box with the two junction box screws as shown.
The side of the single bar marked "GND" must face out. The
junction box is not included.
4. By measuring, determine correct cord length needed for proper
hanging height. NOTE: slide wire clip to the proper position, then
you may properly cut the cord is a too long part.
5. Connect the electrical cord as Shown in Fig.2, making sure that all
wire nuts are secured. You may have to wrap the connections with
electrical tape. If your outlet has a ground wire (green or bare
copper), connect the fixture ground wire to it. Otherwise connect
fixture’s ground wire directly to the Mounting plate with the green
screw provided. After wires are connected, tuck them carefully
inside the Junction Box.
6. Install the canopy(A) onto the junction box, the pipe thread protrude
from the hole in the canopy and lock it securely with the column
nut(B), then lock the cord securely with the plastic screw. Raise the
shade(D) onto the lamp holder, lock it securely with the check
ring(E). NOTE: THE SHADE(D) OF THE PRODUCT MAY VARY.
7. Install the light bulb(not included) in accordance with the fixture’s
specifications. NOTE: DO NOT EXCEED THE SPECIFIED
WATTAGE!
Your installation is now complete. Return power to the
junction box and test the fixture.
Boxscrew
Singlebar
A
B
C
D
E
N
NO Lettering
HOUSE
Black
WIRES
(Hot)
FIXTURE
WIRES
Lettering
WIRES
FIXTURE
Bare
FIXTURE
WIRES
(Ground)
HOUSE
(Neutral)
WIRES
White
Green or
WIRES
HOUSE
Copper(Ground)
Yellow
Thread
( L ) ( N )
( )
FIG.2
FIG.1
©COPYRIGHT ALL RIGHTS RESERVED.
Thank you for purchasing our product.
Need assistance with parts or assembly? Please call customer service