Installation & Assembly

ASSEMBLING & INSTALLATION INSTRUCTIONS
The drawing shown may not exactly match the product enclosed. However, the installation
instructions do apply to this product.
 WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
 ATTENTION! COUPER LE COURANT AU FUSIBLE OU UN DISJONCTEUR.
ASSEMBLING THE FIXTURE (Fig.1).
*Shut off the power at the circuit breaker and remove old fixture, including the
old small hardware.
1. Carefully unpack new fixture and lay all the parts on a clear surface. Take care not
to lose any small parts necessary for installation.
2. Install the light bulbs(not included) in accordance with the fixture specifications.
NOTE: DO NOT EXCEED THE SPECIFIED WATTAGE!
3. Raise the glass(L) into the fixture body(C). Attach the cover(A) onto the fixture
body(C), lock it securely with hex nut(B).
4. Screw the pole(D),(E) together tightly, follow wiring instructions carefully (see
fig.2).
5. Put the pole(G) onto the concrete base using the mounting knob(H).
A. The depth of the base will depend on local soil conditions and frost line. The
diameter of the base should be 305mm in order to hold the anchor bolts on
the plate.
B. Take the three bolts(J) and run a hex nut(K) fully down each part of the
threaded section. Insert the bolt(J) to the template(I) and secure with the
second hex nuts.
C. Mix and pour the concrete into the former until it reaches the top. Push the
assembly into concrete until the plate are 0.25 inches above concrete.
Leaving 2.5 inches of the thread above the concrete.
D. It is important to level the template before the concrete sets.
6. Install the fixture together with the pole(D),(E) onto the pole(G),secure them using
the machine screws(F).
CONNECTING THE WIRES (Fig.2)
*Feed the fixture wires through the pole(D),(E).
1. Take the black wire(hot) from the outlet box and the black wire of fixture and twist
bare ends together. Twist wire connector onto end of wire until snug.
2. Repeat same process with white wire(neutral) from outlet box and white wire of
fixture. NOTE: Twist wires together in the same direction you twist the wire
connector onto wires.
3. If your outlet box has a grounding wire (green or bare copper), attach this wire and
the bare copper wire from the fixture together as step 1.If junction box has no
ground wire, attach the bare copper fixture wire to the green ground screw in the
bottom of the pole(G).
4. Tuck the wire connections neatly into the pole. Take the fixture body(C) mount
onto the pole(D) .
Your installation is now complete. Return power to the junction box and
test the fixture.
C
A
B
L
FIXTURE
WIRES
Black
or
Smooth
HOUSE
WIRES
Black(Hot)
FIXTURE
WIRES
White
or
Ribbed
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
White
(Neutral)
HOUSE
WIRES
Green or Bare
Copper(Ground)
Fig.2
Fig.1