Installation Manual

Larson Electronics LLC www.Magnalight.com
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone] - E: [e-mail]
EPL-48-2L
WARNING: Do not attempt installation until you are familiar with all warnings, precautions, and
procedures outlined within this instruction sheet.
INSTALLATION PRECAUTIONS
 Do not install fixture in any classified location where the marked operating temperature exceeds
the ignition temperature of the hazardous atmospheres.
 Consult fixture nameplate for the suitability ambient temperature shown on the nameplate.
 Refer to fixture nameplate for minimum supply wire temperature rating.
 Verify that the supply voltage agrees with fixture rating as indicated on nameplate.
 All local and national electrical/building codes must be followed when installing this lighting
fixture. For code interpretation, consult your local authority.
 Product must be used only with glass tubes intact and all cap threads fully engaged. Do not use
if glass tubes are cracked or damaged.
Caution: Only use lamp size, type and /or wattage as shown on fixture nameplate.
INSTRUCTIONS FOR INSTALLING
We strongly recommend that only a licensed electrician install this product.
WARNING: Make sure that the power is disconnected before installing. This fixture is extremely heavy
and must be mounted to a surface that can structurally support the load.
NOTE: This fixture requires a minimum of 50 inches of clearance from re-lamp end for lamp
replacement. An optional drop mounting kit that will allow for end to end row mounting is available,
please consult factory.
WARNING: Do not let fixture hang on one bracket at any time. Failing to comply can result in
breakage of end casting or mounting bracket, allowing the fixture to fall, which can cause serious
injury or death.
 The mounting brackets are shipped installed on the fixture.
 Install the brackets to wall or ceiling with two 3/8" bolts (not supplied) at center measurements.
 Fixture is now ready for mounting.
It is strongly suggested to use two licensed electricians to proceed with the final mounting of the fixture
to avoid any possible personnel injury or damage to the fixture as the unit weights up to 46lbs (21.0 kg)
and will be slightly awkward to hold in position and attach to brackets mounted on wall or ceiling.
Depending on mounting height and scaffolding, a hydraulic man–lift or two good quality ladders should
be used.