Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
GL-7900T
NOTE: The remote control is a transmitter. The light contains a receiver. The light is always “hot”. The
light is constantly listening for a transmitter as long as it is connected to power. Thus it is critical that
you disconnect the power from any light you do not wish to reprogram. All lights within 200 feet of a
controller (transmitter) must be disconnected from their power before completing this procedure.
 Golight controllers have a series of dip switches on the back of the controller.
 The dip switches are accessed by removing the battery cover.
 By default, all dip switches are set to the zero position. Moving any one dip switch
changes the channel for that transmitter (controller). Once you have changed a dip
switch, please proceed to Step 1.
1. Disconnect the power to the light that you wish to control with the transmitter with the
new dip switch setting. For cigarette plug models, this means pulling the cigarette plug
out of the socket. For hard wired models, you may need to physically separate the
crimped connection. On vehicle installations, you might need to pull the fuse for that
connection.
2. Press and hold down the On/Off button on the transmitter (controller).
3. Continue to hold down the On/Off button on the transmitter (controller) while
reconnecting the power to the light. Wait 5-8 seconds. The light bulb should turn on.
4. Now that remote controller (transmitter) will communicate with the light only.
NOTE: When you install multiple Golights on one vehicle, vessel or other single power source,
connect each Golight to a separate fuse.