Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
LEDSL-10W
Before installing your light, please read all the instructions below.
INTRODUCTION
The light adopts high power LEDS as light sources with unique appearance, compact structure,
convenient operation, and diversified flash patterns. With superior circuit design, its characteristics are
high brightness, low working current, easy installation and long service time. It is specially designed to
assist all types of emergency vehicles. Users can easily find out and confirm the flashing mode needed
by special indication.
Red: Vin + Black: Vin - White: Trigger (touch with vin+) Green: Sync Signal
TECHNICAL DATA
Working Voltage: DC10V-DC30 Lighting Power: 10W
Color Options: Red, Blue, Amber, And White Mounting: Permanent
Flash Patterns: 14
1. Quad Flash and Single Flash (T=710MS)
2. Quad Flash (T=710MS)
3. Double Flash (T=710MS)
4. Single Flash (T=710MS)
5. Double Flash and Single Flash (T=710MS
6. Five Consecutive Flash (T=710MS)
7. Single Flash 1 and Single Flash 2 (T=710MS)
8. Single Flash (T=1000MS)
9. Single Flash (T=400MS)
10. Single Flash (T=200MS
11. Single Flash (T=800MS)
12. Double Flash (T=400MS
13. Slow Single Flash and Quick Single Flash (T=279MS)
14. Slow Single Flash and Quick Single Flash (T=1180MS)
WARNING
This light utilizes high-intensity LED lamps. Do not stare directly into the light while it is on as
momentary blindness and/or permanent eye damage may occur.