Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
SCLED-H5
CAUTION
 Do not submerge in liquids.
 CAUTION: Risk of Electrical Shock—Use in Dry Locations Only.
 Re-charge batteries using the charger provided with the light.
 Do not attempt to charge the light using a different charger as this may cause damage and will
void the warranty.
 Do not operate the light or battery charger in a hazardous environment containing flammable
gases or dust.
OPERATION & MAINTENANCE
 Use in dry locations only.
 Unit should operate continuously for 5 hours on fully charged battery.
 Keep the unit free from grease and dirt by using a damp cloth with mild detergent, or waterless
hand cleaners.
 This removes dirt from scratches in outer tube and will provide the best output at all times.
 If tube is damaged or badly scratched, it is easily replaced and is available as a replacement
part.
 Do not use solvents such as gasoline to clean unit as it makes the parts brittle.
 Do not allow brake fluid to contact outer tube as it will cause permanent damage.
CHARGING THE BATTERY
 The battery has a fuel gauge indicator light that blinks to show the battery charge level. When
fully charged the indicator light will blink rapidly, slowing down as the battery charge drops.
NOTE: The battery has an automatic shut-off feature that will prevent the user from draining the
battery down to a point of damage.
 When the battery charge indicator is blinking slowly, remove the battery from the light fixture.
 Plug charger jack onto battery charger port as noted on the battery.
 Indicator light on charger will be red while charging and will turn green when the battery is fully
charged.
 Charger is equipped with a trickle charge feature and will not damage the battery if left
connected short term. Manufacturer does not recommend leaving the charger connected to the
battery while in storage.
 Charge batteries in dry locations only.