Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
GL-302X-D
MOUNTING INSTRUCTIONS
 Determine the appropriate location for the dash mount control and create a 2” opening to
accommodate the cylinder on the rear of the remote.
 Remove the outer rubber cover and affix the control to the dash with the four screws provided.
The word “TOP” is embossed on the control and should be situated accordingly.
 All wiring should be undertaken with power removed from the system.
o First, attach the connector on the wiring harness. There is a black connector and a white
connector and each should be connected in correspondence.
o Next, join the leads at the remote to 12 volt DC power with appropriate automotive
wire attachments; the red wire is the positive lead and the black wire is the negative
lead-the unit is polarity sensitive and care must be taken to observe this.
Note: Once the power is applied to the system the light will pan and tilt prior to bulb illumination. As a
safety feature, the control is backlit to indicate bulb illumination only.
Each spotlight needs to be wired on a single dedicated circuit and the power fused at 10 amps. With the
power connected, your light is ready for operation.
OPERATION
1. Using the remote control, turn on the light by depressing the on/off button.
2. With the joystick on the dash control, rotate your light to the desired location.
3. The speed of the light rotation can be controlled by depressing the fast/slow button one time
and by depressing it again to restore the original speed.
4. The hard wired dash control will be backlit when the bulb is illuminated.