Specification Sheet

Page: 2
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
Heat Management: Heat is the single largest factor in premature LED failure and color shifting. As a result, many
manufacturers reduce the output of their LEDs to reduce the amount of heat produced. These LED boat lights utilize an
extruded aluminum housing that incorporates an advanced heat radiating fin design which dissipates heat efficiently to
produce the maximum amount of power and longevity from the integrated Seoul Z-Power LEDs. The end result is more
light and longer LED life with higher average lumen maintenance after 50,000 hours.
Voltage Control: These units are able to monitor and adjust input current to maintain the correct LED voltage levels
regardless of input levels ranging from 9 to 50 VDC. These LEDLB series light bars can operate on current ranging from 9
to 50 VDC without any modifications necessary as a result. This multi-voltage capability makes these units ideal for mobile
and stand alone applications such as those found on boats, heavy equipment and vehicles where power systems don’t
always operate with 12 volts and external generators, transformers or inverters are impractical.
LED10W-6R-M 35° Flood Beam
(Opt)
LED10W-6R-M 10° Spot Beam
(Stnd)
Durability: The LED10W-6R-M LED light from Larson Electronics offers IP68 rated construction that is designed to
withstand tough environmental and operating conditions. These units can operate in temperatures ranging from -40
degrees Celsius to 85 degrees Celsius, are waterproof to three meters and resist ingress of dust, dirt and humidity. The
housings are formed from die cast aluminum, the hardware is stainless steel and the lenses are unbreakable
polycarbonate. The Seoul Z-Power LEDs offer inherent LED resistance to shocks and vibrations, contributing to these units
15.6Grms rating of vibration tolerance. These LED10W series light bars are ideal for use in professional applications such
as law enforcement and the military as well as industrial and commercial settings.
Mounting: These LED10W LED lights feature a smaller profile and lighter weight than our LEDLB-E series lights, making
them ideal for use in locations where traditional lights cannot fit or would block other mounted equipment. The LED10W-6R
-M is suspended within a form fitting trunnion (yolk-type) mount. This trunnion mount has two knureld knobs that can be
loosened, allowing the LED light to be adjusted and the retightened to lock the light into any desired position once mounted.
A single stainless steel stud protrudes from the bottom of the mount, enabling the operator to install the light using a simple
through-hole mount, allowing the unit to be installed anywhere a 3/8-inch hole can be drilled. This particular unit also
includes a200lbs grip magnetic base allowing this unit to be quickly and easily placed wherever it is needed without the
need for permanent mounting hardware.
A 12 foot detachable coil cord with cigarette plug is provided to compliment the versatility of the magnetic mounting system,
allowing this unit to be easily switched from one location to another. Alternative cords include a 21 foot cord with battery
ring terminals (C-21RT), 16 foot straight cord with cigarette plug (C-16CP) or 16 foot cord with battery spring clamps (C-
16BC).
Note: Most Larson Electronics LEDLB, LEDP3W, LEDP10W, and LED10W series LED spotlights and floodlights are
terminated with a Deutsch IPD / LADD DT04-2P connector. The mating connector plug is DT06-2S. Most LEDLB and