Specification Sheet

Page: 3
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
This photo shows an open field illuminated only by ambient light at
approximately 9:00 pm'.
This photo shows the LEDP1X10WRE-RND-C in flood configuration
without colored diffuser. Approx. dimensions of the beam are 100'L X
80'W.
Click Photo to Enlarge Click Photo to Enlarge
Durability: As well as unparalleled heat control, the LEDP WRE series of LED lights from Larson Electronics also offer IP68 rated construction
that is designed to withstand extremes of environmental and operating conditions. These units can withstand rapid temperature changes of -40
degrees Celsius to 85 degrees Celsius, are waterproof to three meters and resist ingress of dust, dirt and humidity. The housings are formed
from extruded aluminum and the lenses are unbreakable polycarbonate. The CREE XLamp XM-L® LEDs offer resistance to shocks and
vibrations and are rated at 70% lumen maintenance after 50,0000 hours of use.
Mounting: These LEDP WRE series LED lights feature a smaller profile and lighter weight than our LEDLB-E series lights, making them ideal for
use in locations where traditional lights cannot fit or would block other mounted equipment. The LEDP1X10WRE-RND-C is suspended within a
form fitting trunnion (yolk-type) mount. This trunnion mount has two knurled knobs that can be loosened, allowing the LED light to be adjusted
and then re-tightened to lock the light into any desired position once mounted. A single stainless steel stud protrudes from the bottom of the
mount, enabling the operator to install the light using a simple through-hole mount, allowing the unit to be installed anywhere a 1/2-inch hole can
be drilled.
Note: Most Larson Electronics LEDLB, LEDP3W, LEDP10W, LED10W, and LEDP WRE series LED spotlights and floodlights are terminated
with a Deutsch IPD / LADD DT04-2P connector. The mating connector plug is DT06-2S. Most LEDLB, LEDP10W and LED10W series lights ship
with mating connector as part of a harness or pigtail, depending on the model. Some larger LED lights like the LEDLB-160X2 or LEDLB-200X2 or
multiple function LED lights (i.e. high/low beam, modulating, IR/Visible combos) will have different Deutsch connectors.
LEDP1X10WRE-RND-C 60° Flood Beam
(Opt)
LEDP1X10WRE-RND-C 10° Wide Spot Beam
(Stnd)