Specification Sheet

Page: 3
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
NOTE ON LAMPS: This fixture comes equipped with two T5HO, T8, or T12HO fluorescent lamps. The F54-T5/850/HO 54 Watt lamps produce
5,000 lumens per bulb for 20,000 lumens per fixture, a 5000 or 4100 Kelvin color and a 20,000 hour rated service life. The F32-T8/841 32 watt
lamps produce 2950 lumens per bulb for 5900 lumens per fixture, a 4100 Kelvin color and a 24,000 hour rated service life. The F48-T12/HO 60
watt lamps produce 4050 lumens per bulb for 8100 lumens per fixture, and a 12,000 hour rated service life. The HALP-48-2L-NSIL has an
electronic universal voltage ballast and operates on a range of voltages from 120V to 277V AC 50/60Hz including: 120 Volt 60 HZ, 220 Volt 50
HZ, 240 Volt 60 HZ and 277 Volts 60 HZ.
Flanged Surface Mount Brackets: Flange type stainless steel mounts attached at each end of the fixture enables it to be simply secured to any
surface. The mounts provide some shock absorbency protection while enabling the user to simply mount the fixture with the through-hole taps
that protrude on each side of the fixture. The mounting holes are 38.25” on center apart along the top of this hazardous location light. The
mounting holes are 3.9” and 7.2” on center across the top of the light.
Suspension/Pendant Mounting: Pendant mount fixtures hang from the ceiling and are suspended by rigid pipe. Each fixture is equipped with
two 3/4” NPT hubs, one on each end of the fixture. Operators bring rigid pipe down to the threaded mounting hubs. Wiring is fed down through
the rigid pipe to one of the NPT hubs and tied in to the fixture’s lead wires, completing the electrical connection. The remaining pendant hub
provides support for the opposite end of the fixture.
Suggested Applications: The HALP-48-2L-NSIL is designed for marine wet and damp locations, where corrosion resistant fluorescent lights are
required. This includes petrochemical facilities, lubrication pits, oil drilling rigs, crew quarters, solvent/cleaning areas, water treatment areas,
processing plants and marine loading docks.
Made in USA Quality Lamp Options
1. Each unit dialectrically tested.
2. Fixture arrives assembled and lamped to reduce installation time and
cost. Flange type stainless steel mounts attached at each end of the
fixture enables it to be simply secured to any surface.
3. Fixture housing constructed of glass fiber reinforced polyester.
4. Relamping done via 8 plastic snap locking latches, which enable the
operator to remove the door and access the lamps.
5. Lamp cover-diffuser constructed of high impact acrylic for corrosion
resistance and lamp protection.
6. 3/4 inch, threaded access hole for wiring conduit.
F54-T5/850/HO – 54 Watt, 5000 lumens per bulb, 20,000 hours life,
5000 Kelvin color
F32-T8/841 – 2950 lumens per bulb, 24,000 hours life, 4100 Kelvin
color
F48-T12/HO – 4050 lumens per bulb, 12,000 hours life, 4100 Kelvin
color
Click here to see the LED version of this light fixture