Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
OPERATION
Tilt Adjustment
The headlamp light pivots on a ratchet. Adjust the tilt angel of the light to illuminate the desired vision
area.
The EXP-LED-HL-X2 has two switches to control the spotlight and the white and colored floodlights. The
flashlight and floodlight functions can be operated independently or together.
 Spotlight Operation
To turn on the spotlight, press the spotlight switch. Press again to turn off.
 Floodlight Operation
The floodlight switch controls 3 floodlight functions.
First Press: White Floodlight on – Full power
Second Press: White Floodlight on – Half Power
Third Press: White Floodlight off – Colored, LED Floodlight on
Fourth Press: Floodlight function off
WARNINGS
 Substitution of components may impair Intrinsic Safety.
 To reduce the risk of explosion, do not mix new batteries with old/used batteries or mix
batteries from different manufacturers.
 To reduce the risk of ignition of a flammable or explosive atmosphere, batteries must be
changed only in a location known to be non-hazardous.
 Risk of ignition – Do not open in a hazardous area.
HEADBANDS
The headlamps include two types of headbands.
Elastic Non-Slip Headband – Use this headband for mounting the headlamp directly to your head. The
non-slip feature will keep the light positioned on the head even with vigorous movement.
Rubber Hardhat Strap – Use the rubber strap on any hardhat. The tacky nature of the strap will keep the
headlamp attached even if the hat is dropped.
CHANGING THE BATTERIES
Use only 3 AA Alkaline, Duracell PC1500, Energizer EN91, or Energizer Lithium L91 Batteries. Lithium
Batteries must be replaced by a qualified technician only.
1. Loosen the battery door screw on the back of the battery pack.
2. Install 3 AA batteries in the pack. Use only approved batteries.
3. Close the battery pack door and tighten the door screw.