Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
Golight Stryker
MOUNTING INSTRUCTIONS
Light Unit/Permanent Mount
 Determine the location for the light on your vehicle or boat.
 Remove the mounting plate from the light.
 Center the mounting plate with the vise screw on the mounting plate to the back.
 Mark the hole locations for the three mounting screws and drill a pilot hole for each with a 1/8”
bit.
 Fasten the stainless steel mounting plate with the 3 #10 – 16x ¾ type AB cross recessed pan
head tapping screws.
 Drill a ¼” hole (wireless) or a 5/8” hole (hardwired) in the center of the mounting plate opening
to accommodate the power wire or wiring harness and connector.
 Attach the connector that is affixed to the underside of the light to the corresponding
connector on the wiring harness (hard-wired).
 Position the connection point beneath the mounting surface, and apply silicone sealant around
wire to seal the drilled opening.
 Wet the mounting surface with a small amount of water or lubricant for easier installation, then
place the light over the mounting plate by sliding the front of the light over the front of the
mounting plate, first pull the light backwards, then seat the back of the light on the mounting
plate.
 Displace the back of the gasket and install the vise screw (provided). Tighten the vise screw
using a Philips head screwdriver. Replace the gasket.
Light Unit/Magnetic Mount
 Select the best location on your vehicle for the magnetic mount Stryker. Make sure the metal
area under the magnetic base is flat and clean to ensure a strong bond.
 Route the power cord into the vehicle through a door frame and connect to 12V power outlet.
 The magnetic mount Stryker should be removed from vehicle’s exterior while traveling at
excessive speeds and in strong wind conditions.
Dash Control/Permanent Mount
 Determine the appropriate location for the dash mount control and create a 2” opening to
accommodate the cylinder on the rear of the remote.
 Remove the outer rubber cover and affix the control to the dash with the four screws provided.
The word “TOP” is embossed on the control and should be situated accordingly.
 All wiring should be undertaken with power removed from the system. First, attach the
connector on the wiring harness. Next, join the leads at the remote to 12 volt DC power with