Installation Manual

Larson Electronics LLC www.LarsonElectronics.com sales@larsonelectronics.com
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
EPL-LEDP405
OPERATING INSTRUCTIONS
Using advanced LED technology, the Magnalight EPL-LEDP405 Instinctually safe rated pen light produces
the brightest light in its category, making it the safest light for all hazardous environments. For its
compact size, it produces an extremely bright beam of 25 lumens / 405 lux at three feet, making it the
brightest penlight on the market. It’s so bright you can use it as a primary flashlight. Its sleek design is
ergonomically constructed to allow maximum grip, but when you need an extra hand you can go “hands
free” with a built in magnetic clip. It’s the safest flashlight for the world’s hazards.
This light is equipped with a tail mounted push-button switch. By lightly pushing on the switch, the light
will temporarily illuminate. Depressing it fully until it latches will allow it to be used in an on/off
capacity.
BATTERY INSTALLATION
CAUTION: Do not mix polarity or battery brands. Do not mix old and new batteries.
1. Unscrew head sub-assembly from body.
2. Load batteries into tube, negative end first (correct orientation is marked on the side of the
flashlight body).
3. Screw head sub-assembly back onto body.
CARE AND MAINTENANCE
Periodically, the batteries should be removed and inspected for signs of leakage or corrosion. If any cells
show signs of leakage, remove and replace all batteries.
TROUBLESHOOTING GUIDE
If your flashlight fails to light:
1. Check to be sure all batteries are installed correctly and are in good condition.
2. Check battery contact points for non-conductive film build-up. Use an emery board or fine
sandpaper to remove any residue.
3. Check to be sure that the head is tightened properly.

Summary of content (1 pages)