Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
EXP-LED-FX2
NOTE:
For personal safety, always confirm the rating of any known hazardous or potentially hazardous
location where the flashlight is planned to be used. These areas include fuel storage areas below
decks on boats, fuel or chemical transfer or storage facilities and areas where the atmosphere
contains chemicals or particles, such as grain, dust or metal powders. Areas with potentially
explosive atmospheres may not be posted. If you are unsure of the environment contact the Safety
Director or agency where the environment in question is located. A listing of the rated classes,
division, groupings and zones of gasses, vapors and combustible materials is available in the
National Fire Protection Administration (NFPA) Classification of Flammable Liquids and Combustible
Materials section of the 2004 edition of the NFPA-70 manual. It is available at www.nfpa.org. This
light has two body switches that control the flashlight and the floodlight. The flashlight and
floodlight functions can be operated independently and together.
INSTALLING OR CHANGING THE BATTERIES:
To reduce the risk of ignition, flammable or explosive atmosphere, batteries must be changed only
in a location known to be non-hazardous.
1. Unscrew the lens bezel.
2. Shake out the reflector/battery carrier.
3. Install 3 AA batteries in carrier.
4. Replace core carrier in flashlight housing. Align core with switch.
5. Replace the lens bezel.