Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
LED3M‐WPG
OPERATING INSTRUCTIONS
Thank you for selecting the LED3M‐WPG, a truly remarkable portable light. As with any professional
tool, reasonable care and maintenance of this product will provide years of dependable service. Please
read these instructions before using your LED3M‐WPG. It includes important safety and operating
instructions that should be saved.
SAFETY
 Before using the DC power cord, read all instructions.
 Do not abuse the cord. Never carry the light by the cord or yank it to disconnect the cord from a
receptacle.
 Plug DC cord directly into cigarette lighter or your car’s DC outlet.
 Do not operate with a damaged cord. Have damaged cords or plugs replaced immediately.
 Unplug your LED3M‐WPG from DC power cord before attempting any routine cleaning or
maintenance.
 Do not try to repair the light or cord yourself. Take it to a qualified service facility or return it to
the factory.
OPERATING THE LIGHT
 The LED3M‐WPG can be operated using 4 “C” sized batteries or directly from a 12V DC cigarette
lighter port using the adapter.
 The trigger switch is located on the pistol grip of the light. Depress the button once to turn the
light on or off.
 The mode switch is located on the side of the light. Rotate the mode switch to select high, low,
or strobe.
BATTERY REPLACEMENT
 Loosen the thumbscrew on the back of the LED3M‐WPG.
 Remove the expired batteries and replace with fresh “C” cell alkaline batteries following the
polarity indicators located in the battery compartment.
 Close the back of the light and tighten the thumbscrew.