Specification Sheet

Page: 2
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
The picture above shows the beam produced on the HL-85-HID model in spot mode. Unlike most green lens configurations, replacing the
clear lens with the green lens (instead of a snap on lens) preserves the beam length and power.
The picture above shows the beam produced on the HL-85-HID model in flood mode. Unlike most red lens configurations, replacing the
clear lens with the green lens (instead of a snap on lens) preserves the beam length and power. This is particularly important in flood
mode, where the beam is already diffused.
The green lens and reflector assembly is simply attached. The clear lens and reflector assembly is "spun" off. Our HL and RL spotlights
enable the user to adjust the beam from spot (narrow and long beam) to a flood (short, wide and soft) beam. This is done by rotating the
lens and reflector assembly. By continuing the counter clockwise rotation you can move from spot to flood, to completing the removing the
assembly. The green lens and reflector is simply spun back on in its place.
Part #: HL-XX-GL (71611)