Installation Manual

Larson Electronics LLC www.LarsonElectronics.com [e-mail]
9419 E US HWY 175, Kemp, TX 75143 - P: [phone] - F: [phone]
EXP-LED-PL2
WARNING:
 To prevent ignition of a hazardous atmosphere, batteries must only be replaced by a technician
in an area known to be non-hazardous.
 Use only energizer E92, EN92 or Duracell MX2400, MN2400, PC2400 batteries.
 To reduce the risk of explosion, do not mix old batteries with used batteries, or mix batteries
from different manufacturers.
 Substitution of components may impair intrinsic safety.
 Risk of ignition – Do not open in a hazardous area.
NOTE: For personal safety, always confirm the rating of any known hazardous or potentially hazardous
location where the flashlight is planned to be used.
OPERATION
A single tail switch turns the light on and off. The switch also provides a momentary on/off function.
INSTALLING OR CHANGING BATTERIES
CAUTION: To reduce the risk of ignition of a flammable or explosive atmosphere, batteries must be
changed only in a location known to be non-hazardous.
1. Loosen the locking screw located on the side of the lens.
2. Unscrew the lens bezel.
3. Install 2 AAA batteries in the carrier. Use only approved batteries: Duracell PC2400, MX2400,
MN2400, or Energizer EN92, E92.
4. Replace the lens bezel.
5. Tighten locking screw.