Specification Sheet
Page: 1
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: 903.498.3363 Fax: 903.498.3364 Email: sales@LarsonElectronics.com
Waterproof Transformer Converts 120-277V AC to 12/24 Volts DC - 16 Amps Max
Part #: DCP-16
The Larson Electronics DCP-16 Waterproof Power Supply converts commonly used 100-277VAC electrical current to 12VDC @16
Amps. This converter is designed to be hardwired into building, boat or vehicle electrical supplies where the voltage is typically within
the 100-277VAC range and reduces it to 12VDC or 24VDC, allowing users to use standard AC power to operate equipment like our LED
light bars and HID Golights that require low voltage DC.
The DCP-16 192 watt power converter provides a safe and effective way for users to tap into and utilize common 100 to 277 Volt AC power
sources and convert this current to 12 Volts DC or 24 Volts DC for use with equipment that requires 12/24 volt DC electrical power. This unit can
be operated with input current ranging from 100 to 277 VAC and will output 192 watt 12 Volt DC current at 16 amps or 24 Volt DC current at 8
amps. This power converter features an IP67 rated waterproof design, making it suitable for indoor or outdoor use and is wet-damp area
approved. This converter includes integral short circuit, over voltage, over temperature and overload protection that will shut down the unit or
reduce output in case of faults and overloads to protect the unit and connected equipment from damage.
The small size and wide input voltage range of this unit make it ideal for indoor-outdoor operation of Larson Electronics LED light bars, Golights
and other equipment that requires 12VDC current and anywhere 12 volt DC power is not readily available. Measuring 9.6 inches long by 2.6
inches wide by 1.5 inches deep, this unit weighs approximately one pound and is mounted with two conventional screws via slots that allow
removal and repositioning simply by loosening the screws.
This converter comes with clearly labeled input and output leads that are approximately 1 foot long and stripped and tinned for hardwired
connections using butt splice connectors, wire screws, plates, etc.