Installation Manual

Larson Electronics LLC WWW.MAGNALIGHT.COM
9419 E US HWY 75, Kemp, TX 75143 - P: 903-498-3363 F: 903-498-3364 E: [e-mail]
1
LED Light Wire Harness Installation Instructions
The Wiring Harness supplied with Magnalight LED spotlights is assembled with a twenty foot 3 conductor
SOOW cable with a male deutsch connector on one end of the cable.
1. To connect the wiring harness to the spotlight push the male deutsch connector located on the end of
the cable into the female deutsch connector protruding from the light.
2. Take the blank end of the cable and carefully strip back about an inch of the outer jacket to expose the
conductors inside the cable. The cable consists of three wires (white, green and black). The Black wire is
the ground wire, the white wire is the positive and the green wire is a signal control wire (for dimming
applications).
3. Once the white and black wires have been connected to their mates on the power source, power will be
provided to the led light via your low voltage power source.