Specification Sheet

Page: 1
Larson Electronics LLC www.LarsonElectronics.com
9419 E US HWY 175, Kemp, TX 75143 Phone: [phone] Fax: [phone] Email: [e-mail]
LED IR Illuminator Light - Magnet Mount - 12 LEDs - 36 Watts - 9-42 Volts DC - 16' Coil Cord
Part #: LEDLB-12-IR-M
Buy American Compliant
The Larson Electronics LEDLB-12-IR-M LED Light Bar offers high infrared light output in a light weight, durable, low profile housing
combined with a versatile magnetic mounting system that provides convenience and secure attachment to vehicles, equipment and
any flat metallic surface. This IP67 rated infrared LED light bar is waterproof to one meter and produces 3,600mW of infrared light
while drawing only 36 watts of power at 3 amps from a 12 volt electrical system. This light can run on any voltage from 9 to 42 Volts DC
and produces an infrared light beam that can only be seen through the use of night vision goggles. 850Nm versions have a very slight
red glow around the LED emitters when viewed from a certain angle while 940Nm versions are completely invisible to the naked eye.
Click here to see the LED version of this
The LEDLB-12-IR-M LED light bar from Larson Electronics produces a 550' long by 70' wide infrared light beam with 3,600mW of light in the
infrared spectrum while drawing only 36 watts @3 amps from a 12 volt electrical system. Twelve Edison Edixeon® three watt Infrared Emitters
LED's producing 300mW each are paired with high purity 10° degree optics to produce a tightly focused spot beam with limited spread or light
spillage. We also offer optional floodlight versions with 35° degree optics to produce a wider infrared beam spread. We offer 850Nm versions that
are ideal for most IR applications and 940Nm versions that require the latest IR equipment for full effectiveness.
These LED light bars are IP67 rated and waterproof to one meter, sealed against intrusion by dust and dirt and ruggedly
constructed to withstand demanding environments and applications. The entire Larson Electronics LEDLB series are
constructed of extruded aluminum and feature rubber isolated mounts and unbreakable polycarbonate lenses to provide
durability and resistance to vibrations, impacts, waves, hard rains, sand and high winds.
This light is equipped with two 100lbs grip magnetic mount bases and a 16 foot coil cord ending in a cigarette plug
connector. This magnetic base mounting allows fast and easy setup of this light on vehicles and equipment and will hold
the fixture in place at speeds up to 80mph provided the mount is properly affixed and secure.