Installation Guide

202220565 CLASSIC-VIEW SERIES
3
Facing the house from the outside, measure the height of the
opening as illustrated in Figure 8. This measurement is taken
from the top of the door opening (underside of the trim board)
down to the bottom threshold.
Take two measurements (A and B) as shown to determine the
threshold angle to cut the Z-bar.
Measure the Opening
3
FIGURE 8
FIGURE 7
FIGURE 6
The top of the z-bar should be at the correct position—1/16 to
1/8" above the door. The bottom of the z-bar must be cut to the
correct length (opening height), taking into account the angle of
the threshold. See Figure 9.
Using the measurements taken in step 3, determine the angle to
cut the z-bar. Transfer this measurement to the Z-bar, then make
a cut 1/16" less than your measurement to allow room for top drip
cap. Save the z-bar cut-off scrap for steps 6 and 9.
FIGURE 9
Cut Hinge-Side Z-Bar to Length
4
HINT:
Measure twice.
Cut once!