Installation Guide

6
202220565 CLASSIC-VIEW SERIES
STANDARD TOP VENTILATION (Figure 21)
Screen in Top Position
1.Remove operating insert from door by sliding sash all the
way to the bottom (to clear handle) and then tilt out.
2.Remove stationary insert in the same manner as step one.
CAUTION: Screen can slide downward when glass sash is
being removed.
3.Slide screen sash to bottom and tilt outward to remove.
4.Reverse above steps to install glass and screen sashes.
OPTIONAL BOTTOM VENTILATION (Figure 22)
Screen in Bottom Position
1.From a location below the handle, insert the stationary
insert tilt barrels into the outer track and slide to the top.
2.Position screen sash below glass, with tilt barrels down and
screen spline facing inside of door. Allow stationary insert to
rest on top of screen.
3.Place operating insert in the inner track. NOTE: Operating
insert has a ledge that extends from the bottom to aid in
operation.
Retainer Installation/Removal
13a
Glass and Screen Sash Removal:
Self-Storing Models
13b
INSTALLATION
Your door is shipped with the screen and glass inserts in the window
opening. After the door is installed either the screen or glass is held in
place by plastic retainer strips.To install the retainers, start one end of the
retainer into the track at the top or bottom of the window and push retainer
into the track as shown. Continue to snap retainer into place from that end
(moving toward the opposite end in increments of 4–5"). At the end, you
will hear a “snap” as the last portion of the retainer goes in (Figure 20A).
FIGURE 20A
FIGURE 20B
REMOVAL
Place large flat-nose screwdriver blade in groove next to
door frame (approximately 1/2" from top or bottom of
window). Tilt screwdriver at slight angle, tipping handle
toward door frame, then tap end of screwdriver—
“popping” out end of retainer. Grasp retainer and remove
(Figure 20B).
NOTE: Make sure the print on the retainer faces you during installation
NOTE: For tight retainers, a bar of soap can be used to lubricate before installation.
ATTENTION:
Glass insert will be
held tight by vinyl
retainer strips when
installed correctly.
CAUTION!
If glass insert is
loose–vinyl retainer
strips are NOT
installed correctly.
Remove retainer
strips and re-install
them per the
instructions
.
REMOVE ALL PROTECTIVE TAPE FROM THE DOOR FRAME NOW.
FIGURE 21
FIGURE 22