Installation Guide

202220565 CLASSIC-VIEW SERIES
7
Larson Storm Door Warranties
CLASSIC-VIEW
TM
During life of door, new door at no charge.
Limited Lifetime Warranty
HARDWARE
H a rd w a re warranty is 1 y e a r, covering workmanship and mechanical parts (brass
1-Year Warranty finish is not covered under the warranty). Brass is like fine silver, it needs occasional
m a i n t e n a n c e . To maintain your brass finish, see the “General Care and Maintenance”
section on page 10.
STORM DOOR WARRANTY LIMITATIONS: Modification of door will void warranty. Screen damage, glass breakage, or wind damage is not covered under warranty.
In order to obtain performance under these warranties, the original owner shall do the following:
1. Send in the warranty registration card within 30 days following purchase.
2. Notify authorized dealer of defect, with proof of purchase.
Install Screw Cap Covers
14
FIGURE 23
FIGURE 24
Larson has 2 different types of screw covers. See
Figure 23 or 24 to determine which type you have.
Refer to the below instructions for further detail.
1. After the door is installed, apply the drip cap screw
cover. Cut screw cover to correct length if needed
using a scissors or a tin snip. Attach screw cover
per illustration. Starting at one end, snap the cover
on working your way towards the other end.
2. Cut the latch and hinge z-bar screw covers to
length—matching the z-bar lengths respectively.
3. Attach the latch and hinge
z-bar screw covers as described in step #1.
*NOTE:
Some models do NOT come
with screw covers!