Installation Guide

8
202220565 CLASSIC-VIEW SERIES
Classic-View
™
Series Storm/Screen Doors
CLOSER INSTRUCTIONS
FIGURE 25
FIGURE 27
FIGURE 26
CLOSER ASSEMBLY PREPARATION
1. Slide hold-open washer onto closer rod as shown. Pull rod out of
closer so that there is a 1/4" gap per Figure 25 (insert small
screwdriver in rod hole to provide pulling grip). Position washer
behind flanges and against the closer. Remove screwdriver. This
will give proper tension for installation. (Do not change until
installation is complete.) See Figure 25.
2. Assemble the closers as shown in Figure 27. Attach front hole in
closer to door bracket (long connecting pin). Attach closer rod to
side jamb bracket (short connecting pin) with open side of jamb
bracket toward storm door (see arrow on bracket).
3. Close and latch door.
INSTALLATION: ONE CLOSER MODELS
1. To install the closer, hold closer assembly 1-1/2" down from top of
door and hold jamb bracket 1/4" back from storm door. Mark jamb
bracket holes and two holes in door bracket.
2. Fasten jamb bracket to jamb with four #10x1 1/2" screws (see
Figure 26). The open side of the jamb bracket should be toward
the storm door (see arrow on bracket).
3. Close and latch the door. Hold the closer and door bracket level
and mark the location for the insertion of the door bracket screws.
Drill 1/8" starter holes. CAUTION: Do not drill through the
outside of door. Install two #10x1/2" screws in bracket.
4. To hold the door open: Open door. Slide hold-open washer over
flanges toward cylinder on closer.
INSTALLATION: TWO CLOSER MODELS
1. To install the top closer, hold closer assembly 1-1/2" down from top
of door and hold jamb bracket 1/4" back from storm door. Mark
jamb bracket holes and two holes in door bracket.
2. Fasten jamb bracket to jamb with four #12x1" screws (see Figure
27). The open side of the jamb bracket should be toward the storm
door (see arrow on bracket).
3. Close and latch the door. Hold the closer and door bracket level
and mark the location for the insertion of the door bracket screws.
Drill 1/8" starter holes. CAUTION: Do not drill through the
outside of door. Install two #10x1/2" screws in bracket.
4. To install bottom closer, hold assembly level 1-1/2" from bottom of
door and hold jamb bracket 1/4" from storm door. Mark and attach
as shown in steps 1, 2, and 3. NOTE: Bottom closer may need to
be applied over the door expander in some cases.
5. To hold the door open: Open door. Slide hold-open washer over
flanges toward cylinder on closer.
NOTE: Be sure door opens and closes freely before installing the
closer. Some models have two closers and others have one closer.
Closer Installation
1