Installation Guide

Place the door in the opening with the hinge rail resting

on the threshold. Push the hinge rail tightly against the

brickmold. Check to make sure your door is square in

the opening. Shims may be used behind the hinge rail if

needed.

Pre-drill a 1/8” pilot hole through the top and bottom hole

in each hinge. Fasten the door to the brickmold using all

of the pre-drilled holes with the #10x2” screws provided.

Remove and discard the center screw from each hinge.

Pre-drill a 1/8” pilot hole through the center holes. Fasten

with #10x2” screws.

3 Place Door In Opening

Install the handle and deadbolt following the handle

manufacturer’s instructions.

4 Install Handles (Sold Separately)

Position the top rail above the door and close the

door. Align the end of the top rail with the edge

of the hinge rail. Install a #8x1" screw through the

hole closest to the hinges. Adjust the top rail to

create an even reveal between the door and the top

rail. Install a #8x1” screw through the remaining

pre-drilled holes.

5 Install Top Rail

Door

#10x2” SCREW

#8X1” PAN HEAD SCREW

Door

Align Edges

ACTUAL SIZE