Installation Guide

The closer must be installed in the center of the door on
the mullion between the glass sashes. See instructions in
the closer kit for bracket installation.
The storm chain is to be installed at the top of the door.
Instructions are provided.
11 Closer and Storm Chain Installation
Slide the rubber sweep into the track of the bottom
expander that offers the best contact with the threshold.
With a pliers, crimp the track on both sides to hold the
sweep in place and cut the sweep to length.
Place the expander on the door and adjust it until the
rubber sweep lightly touches the threshold. Drill a
1/8” pilot hole through the expander and into the door
approximately 6” from each end of the expander. Fasten
the expander with two #8x1” Phillips pan head screws.
NOTE: Some installations may require removing and
reinstalling the bottom glass clips through the expander.
10 Install Bottom Expander
#8X1” PAN HEAD SCREW
Locate the two pre-drilled holes on the hinge
side of the door. In the center of the hinge rail,
make two marks that line up with those holes.
Drill a 1/8” pilot hole through the hinge rail
approximately 3/4” deep ensuring that the holes
are aligned with the center of the pre-drilled
holes in the door.
Locate the vault pins in the closer kit and screw
them into the hinge rail.
9 Install Vault Pins
VAULT PIN
SECURITY
HINGE
DOOR
STEEL
Factory drilled
5/8” hole
#8 X 1-1/2” FLAT HEAD SCREW
VAULT PIN
SECURITY
STEEL
DOOR
HINGE
Closer Bracket
Closer Bracket
Crimp
ACTUAL SIZE
VAULT PIN
ACTUAL SIZE