Manualshelf

Installation Guide

ManualsBrandsLARSON ManualsGarage Door ScreensE800749696
12345678910
PAGE 9
J
B
B
L
N
L
N
J
LEFT
RIGHT
C
I
O
B
E
4A
4B
6
4C
Windy conditions may affect the performance of a retractable screen. Retract the
screen in windy circumstances, during inclement weather, when not needed to
support immediate ventilation or during prolong periods when not used.
CHAIN LOCK
Position G-Chain Lock on the side wall jamb near the A-Screen Cassette
Assembly where it can engage the Operating Wand chain. Attach to the jamb
using a N-#8 x 1" (25mm) Phillips Panhead Screw.
When the screen is fully extended and being used, the Operating Wand should be
operated so that the screen fabric is taut in the opening. If necessary, the exposed
chain can be secured by the G-Chain Lock. This will help retain the screen fabric
in the B-Inside Rails as wind blows against the screen fabric.
5
FOOT RELEASE LEVER
The I-Foot Release Lever is an optional feature that makes it easier to slightly
rotate the C-Pull Bar in order to disengage the J-Pull Bar Locks [Fig FIG 4C]
without bending over. Before installing, position the I-Foot Release Lever 12" to
20" from the end of the C-Pull Bar on the side closest to the Operating Wand.
Attach the I-Foot Release Lever to the C-Pull Bar using two O-#6 x 3/8” (9mm)
Phillips Panhead Screws.
6
INSTALLING SIDE RAILS
Install the J-Pull Bar Locks at the bottom of each B-Inside Rail. Be sure that
the J-Pull Bar Lock can engage the C-Pull Bar as shown in image [Fig 4C]. Slide
B-Inside Rails onto the tabs protruding from the E and F-Cassette End Caps, with
the shorter pile to the inside [Fig 4D]. Use an 1/8” drill bit and first drill through both
sides of the B-Inside Rails where they are to be fastened. Next, using a 3/8” bit, drill
through the outside face only. This will allow you to snap the L-Screw Cover Caps in
place. Square and attach B-Inside Rails with N-#8 x 1” (25mm) Phillips Panhead
Screws. Install L-Screen Cover Caps into each hole in the B-Inside Rails.
Using the height adjustment wheels on the J-Pull Bar Locks, adjust the height
to the appropriate level so they easily engage the C-Pull Bar. When correctly
adjusted the latching and unlatching should be smooth and easy.
4
Shorter Pile
4D
See page 10 for Operating Wand Instructions.
GRANDVUE 800 INSTALLATION INSTRUCTIONS
RECESS INSTALLATION