Installation Guide

PAGE 4
PREPARING THE SCREEN CASSETTE
Insert F-End Cap with Spring into the correct end of the A-Screen Cassette
Assembly [Fig 2A] (the assembly will only fit correctly in one end). Make sure to
line up the spring and bushing notches with one of the small slots in the center
screen tube. Wind the spring clockwise the number of turns designated in the fol-
lowing chart and push the F-End Cap with Spring in place on the A-Screen Cas-
sette Assembly. A rubber mallet is helpful to fully seat the F-End Cap with Spring.
Note that the spring in the cassette is for tension only. You will need to raise and
lower the screen by using the G-End Cap Chain.
2
3
SIDE VIEW
GARAGE DOOR HEAD
OUTSIDE
INSIDE
I-Recess Mount Clip
OPENING WIDTH
36”- 72”
73”-120”
120”-140”
140”-192”
SPRING TENSION
25
30
35
40
OPPOSITE END OF CARTRIDGE
Test Chain Guide for smooth operation. If it’s too tight, loosen allen screw. Insert
the G-End Cap with Chain into A-Screen Cassette Assembly and push into place.
The G-End Cap with Chain is setup for internal operation (operating from one
side). If desired this can be disassembled and altered to allow for either internal or
external operation [Fig 2C].
Slide one piece of the J-Weatherstrip into bottom slot of D-Pull Bar and the other
piece into the top of A-Screen Cassette Assembly. The O-Weight Bars are already
inserted inside the hollow of the D-Pull Bar. Now insert the E-Pull Bar End Caps
into ends of D-Pull Bar [Fig 2B].
MOUNTING THE SCREEN CASSETTE
Mount the I-Recess Mount Clips to the inside of opening.When installed, the clips
should be centered above the cassette. Install a P - #8x1”(25mm) Panhead Screw
into the center of the slot to allow front to back
adjustment [Fig below].
Snap the A-Screen Cassette Assembly into place. Secure the
A-Screen Cassette Assembly in place by screwing the F-End Cap
and G-End Cap to the side jamb of the opening. The I-Recess
Mount Clips and A-Screen Cassette Assembly may be reversed
to face toward the inside or outside of an opening depending
upon which side the Pull Chain needs to be accessible. See image
2C for optional user performed Pull Chain routing options.
NOTE: the I-Recess Mount Clips lower the A-Screen Cassette
Assembly in the opening by 1/4”. The same 1/4” gap should be
left above the F & G-End Caps to avoid bowing the cassette.
D
A
J
J
E
E
O
F
A
2A
2B
2C
INTERNAL OR
EXTERNAL OPERATION
(OPTION SET-UP
PERFORMED BY USER)
INTERNAL OPERATION
(STANDARD)
ESCAPE 800 INSTALLATION INSTRUCTIONS
RECESS INSTALLATION