Owner Manual
10
Outswing Door Handle Modiļ¬cation (If needed)
Once the unit is installed, move the gray lock mechanism to the inside of the home.
1. Disengage the handle lock and remove the (2) screws from the handle.
2. Remove both handles (NOTE: the gray latch will be loose).
3. Remove the gray latch from the Slider Bar and reverse it so the logo faces inside the
home, then press the latch over the slider bar.
4. Place the handle with the lock on the logo-side of the gray latch.
5. Align and insert the screws through the screw holes. Position the outside handle over
the screws and align the (6) small dimples with the corresponding indentations on the
inside handle.
6. Tighten the (2) screws.
Right/Left Outswing
Lock Mechanism
ONLY
For assistance with your installation, or additional product information, contact
LARSON Customer Care at www.LARSONdoors.com