Owner Manual

6
1
ASSEMBLE COMPONENTS (CONTINUED)
b. Remove all tape and packaging material. If your
opening falls within the standard range of 32”-
36” width, momentarily extend Slider Bar 2”, and
insert one end of each Track into end of the Screen
Housing. Let the Slider Bar retract. With the notch
towards the front, insert Track straight and move
it all the way to the corner. Make sure the Screen
and Slider Bar End Caps thread through the Tracks.
If the opening is less than 32”, and the top and
Bottom Tracks have been shortened (see page 5),
insert the original uncut ends of each Track into
end of the Screen Housing.
c. Slide Sill Plate Assembly onto bottom Track.
NOTE: Do not deploy screen until it is
assembled to doorway.
WOOLPILE
INSERT TRACK
STRAIGHT INTO
PLASTIC CORNER
TRACK INSTALLED
INTO SCREEN
HOUSING
TRACK WITH
SILL PLATE AND
EXTENDERS
NOTCH AT
SCREEN
FRONT
INTERIOR