EasyLog Bluetooth quick start guide
1 Charge your data logger Your data logger will arrive partially charged. For optimum performance, charge it for 24 hours before use until no battery symbol is displayed. Please use the USB cable provided. Battery states The symbols below show the various battery states: Battery OK/charged Battery low Battery charging No symbol displayed Solid Flashing 2 Install Android™ app available on Google Play™ Before the data logger can be set up, you must install the EasyLog BT app available on Google Play™.
Set-up the data logger Open the EasyLog BT app on your Android™ device and follow the on-screen instructions for connecting your logger. A Bluetooth connection is established after pressing the button on the logger, then selecting that logger from the scanned list in the Android™ app. You will be prompted with a Bluetooth pairing request. Enter the default logger password that is listed on-screen or on the back of the logger.
Android™ app features Within the app you can set the sample rate, temperature scale, temperature and humidity alarms, Bluetooth power-save settings, LCD settings and variable start times. Downloaded data will be saved to your phone’s memory card and can be viewed any time. This data can then be sent via email or your preferred cloud service, to another device or PC for further analysis.
Getting to know your logger LED Status Green & red single flash (together) The data logger is in push-to-start mode Push button to start logging Green single flash The data logger is currently logging No alarm has been triggered No action required Red single flash The data logger is currently logging The low alarm has been triggered! Check your logger’s status using your Android™ device Red double flash The data logger is currently logging The high alarm has been triggered! Check your logger’s status
Getting to know your logger LED Status Green & red single flash (together) The data logger is in push-to-start mode Push button to start logging Green single flash The data logger is currently logging No alarm has been triggered No action required Red single flash The data logger is currently logging The low alarm has been triggered! Check your logger’s status using your Android™ device Red double flash The data logger is currently logging The high alarm has been triggered! Check your logger’s status
Important safety information WARNING: Failure to follow these safety instructions could result in fire, electrical shock, other injury or damage. Repairing or modifying Never attempt to repair or modify Lascar products. Dismantling them, other than for the purpose of changing replaceable batteries, may cause damage that is not covered under the warranty. Servicing should only be provided by an authorized supplier.