User manual

www.lascarelectronics.com
This Help Guide refers to the EasyLog USB Data Loggers
Issue 1_06-2016
Page 10 of 24
EASYLOG SOFTWARE GUIDE
You have the option to set no alarms, one alarm or both alarms.
Depending on the data logger that you are using, you may also be able
to disable the LEDs on the data logger.
Some data loggers allow you to set warning levels and enable a
sounder instead of setting alarm levels.
For each alarm that you have set, you must also set the level at which
the alarm is triggered.
For each alarm that you have set, you have the option to set Hold.
The High Alarm cannot be set lower than the Low Alarm.
If both alarms have been set to Hold, then Hold will only apply to the
alarm trigger level that was first exceeded.
Depending on the data logger that you are using, you may be able to
delay the High and Low Alarm indications until several consecutive
alarm readings have been logged. The logging rate chosen will be
displayed on the page to assist in calculating the number of alarms
that can be ignored.