Operation Manual

Note:

Do not expose batteries to excessive heat such as sunshine, fire, etc. Only recharge-

able batteries must be charged. Used batteries must not be disposed of as household

waste. Please take them to a collection point for used batteries or for special waste.

Ask your local authority for further details. Batteries with the recycling symbol can also

be returned to our dealerships or to our Technical Service.

Battery (NiMH) charging

• Charge rechargeable batteries fully before using the

device.

• Connect the charger to the mains power supply and

the charging socket (G) on the high-performance

rechargeable battery (H). Please only use the charger

supplied; using a different charger will invalidate

the warranty. The rechargeable battery can also be

charged when it is not inserted in the device.

• When the rechargeable battery is being charged,

the LED on the charger lights up red. When the LED

changes to green, charging is complete.

• Alkaline batteries (4 x type C) can be used as an alternative. Insert them in the battery

compartment (I) as per the installation symbols.

• Insert the high-performance rechargeable battery (H) or the battery compartment (I)

into the slot (L) and tighten with the fastening screw (F)

• With the rechargeable battery inserted, the device is ready to run even during

charging.

• If the operation/battery indicator flashes continuously, the batteries need to be

replaced or the rechargeable battery re-charged.

Inserting batteries into the SensoLite laser receiver

• Open the battery compartment (33) and insert the battery as per the installation sym-

bols, observing the correct polarity. Close the cover again.

• In order to preserve the battery life, the receiver switches off automatically if it is not

used for around 5 minutes.

Inserting batteries into the Commander 50

• To insert the battery, open the cover fully (see figure).

Correct polarity must be observed. Close the cover

again fully.