Operation Manual

(13)

(22)

± 4°± 4°

(22)

± 4°

Single slope function

In automatic mode, an axis can be manually set to a certain slope using this function,

even if the ADS tilt function is also active. This means that one axis can be re-adjusted

whilst the other is aligned horizontally and/or vertically. Press the slope/man button to

activate the function and select the X or Y axis. The slope LED lights up, as does the LED

for the X or Y axis. The slope is re-adjusted using the plus/minus buttons. ATTENTION:

This function cannot be used to perform full horizontal levelling, just to adjust one axis.

Turn the vertical plane

Application example: A gradient is to be laid out at the entrance to a garage. For this,

one axis must be re-adjusted and the other aligned horizontally with the garage floor.

IMPORTANT: If a horizontal line is to be moved simultaneously on one wall, the X or Y

axis of the rotary laser must be aligned at right angles to the wall. If this is not done, a

slope will be projected onto the wall. Use the reference beam to set the right angle.

(

OPTIONAL)

(optional)